Abstract:The geotechnical integrity of critical infrastructure can be seriously compromised by the presence of fractures or crevices. Non-destructive techniques to accurately detect fractures in critical infrastructure such as dams and highways could be of significant benefit to the geotechnical industry. This paper investigates the application of shallow seismic and georadar methods to the detection of a vertical discontinuity using numerical simulations. The objective is to address the kinematical analysis of a vertical discontinuity, determine the resulting wave field characteristics, and provide the basis for determining the existence of vertical discontinuities based on the recorded signals. Simulation results demonstrate that: (1) A reflection from a vertical discontinuity produces a hyperbolic feature on a seismic or georadar profile; (2) In order for a reflection from a vertical discontinuity to be produced, a reflecting horizon below the discontinuity must exist, the offset between source and receiver (x0) must be non-zero, on the same side of the vertical discontinuity; (3) The range of distances from the vertical discontinuity where a reflection event is observed is proportional to its length and to x0; (4) Should the vertical crevice (or fracture) pass through a reflecting horizon, dual hyperbolic features can be observed on the records, and this can be used as a determining factor that the vertical crevice passes through the interface; and (5) diffractions from the edges of the discontinuity can be recorded with relatively smaller amplitude than reflections and their ranges are not constrained by the length of discontinuity. If the length of discontinuity is short enough, diffractions are the dominant feature. Real-world examples show that the shallow seismic reflection method and the georadar method are capable of recording the hyperbolic feature, which can be interpreted as vertical discontinuity. Thus, these methods show some promise as effective non-destructive detection methods for locating vertical discontinuities (e.g., fractures or crevices) in infrastructure such as dams and highway pavement.

Application Progress of Nondestructive Testing Technique of Hydraulic Concrete Based on Steady Rayleigh Wave Method

Evaluation of Pipe Axial Defeat Through the Use of Ultrasonic Guided Wave and Matching Pursuit

Application Research on Surface Wave Technique in Crack Depth Detection of Hydraulic Concrete

Application of Surface Wave Method for Nondestructive Testing of Hydraulic Tunnel Concrete

Application of Nondestructive Testing Technology in Quality Evaluation of Plain Concrete and RC Structures in Bridge Engineering: A Review

Application of Resistivity Tomography Nondestructive Detection Technique to Earth-Rock Dam for Longfengshan Reservoir

Corrosion damage detection in reinforced concrete using Rayleigh wave-based method

Status and Progress of Non-Destructive Test Method in Concrete

Crack depth measurement and key points of accurate identification in concrete structures: a review

Axial stress measurement of concrete with nonlinear ultrasonic harmonic method

The application of sound wave CT technology in some bridge concrete nondestructive testing

Wave Field Features of Shallow Vertical Discontinuity and Their Application in Non-Destructive Detection

An non-destructive detecting method based on the shear wave propagation characteristics and its application on grouting quality of an immersed tube tunnel foundation base

Two-step detection of concrete internal condition using array ultrasound and deep learning

Research on visualisation of plain concrete crack depth detection based on tracer and hand-held radar

Concrete Structure Ultrasonic Testing Technology Research Latest Progress and Development Trend

Application of Ground Penetrating Radar and High Density Seismic Mapping Method in Tunnel Concrete Lining Detection

Detection and Identification for Void of Concrete Structure by Air-Coupled Impact-Echo Method

Detection Technology of Lining by Comprehensive Wave Field Method

Concrete Non-destructive Testing Technology and Its Application

Low-frequency Ultrasonic Array Imaging for Detecting Concrete Structural Defects in Blind Zones