Abstract:The Euler–Lagrange method is a great way for multiphase bubble flow simulation, the detailed information of bubbles can be effortlessly obtained, and it is helpful for the efficiency and safety of different industry processes. Traditionally, the computational fluid dynamics-discrete bubble model (CFD-DBM) method has always been used to simulate this flow process. Nevertheless, the ability of the traditional CFD-DBM method is significantly limited in terms of the size ratio between the grid and bubble, where the grid size must be larger than the bubble size. In reality, the bubble may be larger than the grid and the grid/bubble size ratio can be very large due to the effects of complex bubble dynamics (such as the bubble breakup and coalescence) and complex internal flows. To address this issue, an improved CFD-DBM method is proposed in this study, which can be used for the simulation with a wide grid/bubble size ratio in gas–liquid–bubble multiphase simulation, and the volume of fluid (VOF) method is applied to capture the interface between gas and liquid phases. A gradient-based interpolation method is employed to reconstruct the liquid velocity around the target bubble when the grid size is much larger than the bubble size. If the bubble size is comparable with or larger than the grid size, the interphase force correction and the field smoothing will be carried out within a spherical support area. Subsequently, the proposed model is validated by the comparison with a bubble column experiment, in terms of the bubble size distribution and bubble vertical velocity. The results demonstrate the high accuracy of the new method. Finally, the influence of different parameters including normal spring stiffness, critical Weber number, and the range of the spherical support area on the bubble flow is investigated.

Simulation of the Motion of Two Bubbles in Aluminum Foams Produced Process by Using Level Set Method

Interaction of Two In-Line Bubbles of Equal Size Rising in Viscous Liquid

Numerical Investigation of Multi Rising Bubbles Using a Coupled Level Set and Volume of Fluid (CLSVOF) Method

Numerical simulation on motion of bubble under water

Development of a Mass-Preserving Level Set Redistancing Algorithm for Simulation of Rising Bubble

Simulation of Tracking the Fluid-Fluid Interface with the Level Set Method

An Improved Computational Fluid Dynamics-Discrete Bubble Model for Multiphase Bubble Flow Simulation with a Wide Grid/bubble Size Ratio

Numerical Simulation Of Bubbly Flow Using Partially Averaged Navier-Stokes Simulation And A Path Oscillation Model In The Euler-Lagrange Approach

Simulation of Single Bubble Dynamic Process in Pool Boiling Process under Microgravity Based on Phase Field Method

Animating Bubble Interactions in a Liquid Foam

Experimental and Numerical Study on the Bubble Dynamics Near Two-Connected Walls with an Obtuse Angle

Direct numerical simulation of deformable rising bubbles at low Reynolds numbers

Simulation of Spatial Distribution of Multi-Size Bubbles in a Slab Continuous-Casting Mold Water Model

Simulation of Bubbles

Study on the interactions between two identical oscillation bubbles and a free surface in a tank

Numerical Investigation of Initial Stage of Bubble Rise

Modeling and numerical study of particle-bubble-liquid flows using a front-tracking and discrete-element method

The motion and wake characteristics of bottom blowing coaxial double bubbles

Numerical Investigation Of The Interaction Mechanism Of Two Bubbles

Numerical Solution of Single and Two Bubbles Moving in Quiescent Liquid Using Euler-Lagrange Approach

Numerical study of surfactant effects on the rise of a single bubble and two coaxial bubbles