Abstract:The ultrasonic transducer employing helical slots to generate longitudinal-torsional (L&T) ultrasonic vibration is popular in the field of hard and brittle material machining. However, the design approach for this type of L&T ultrasonic transducer is not well established. An improved design model combining equivalent circuit theory and material parameter equivalent method based on stiffness variation was proposed in this study. The structure parameters of the transducer can be obtained according to given resonance frequency and nodal position. The model can further predict electrical characteristics and mechanical responses under specific excitation. For the preliminary verification of this theoretical model and the optimization of the transducer, finite element analyses were carried out to investigate the influences of slot structure parameters on dynamic performances in terms of resonance frequency, frequency separation, and amplitude of L&T vibration. After that, a prototype was manufactured according to the design results, and the measurements of impedance curve and vibration amplitude were conducted. The experimental results indicate that this prototype resonates at 24,920 Hz with an effective electromechanical coupling coefficient of 0.19. Meanwhile, the vibration amplitude in longitudinal direction is 8.1 μm and that in tangential direction is 5.6 μm under 70-V sinusoidal voltage excitation, which are consistent with the theoretical design and simulation results. Furthermore, machining tests demonstrate that surface roughness reduction and surface quality improvement can be gained by adopting this L&T ultrasonic transducer, compared to using the longitudinal vibration transducer. The proposed design approach was validated and this study can provide guidelines for the design of L&T ultrasonic transducer for rotary ultrasonic machining (RUM).

A High Efficient Variable Cross-Section Compound Ultrasonic Wiredrawing Vibration System

Longitudinal wave propagation in a rod with variable cross-section

The Design And Finite Element Analyses Of The Super-Long Ultrasonic Amplitude Transformer

Experimental research of the titanium alloy wire drawing with high power ultrasonic vibration

Design of ultrasonic elliptical vibration cutting system for tungsten heavy alloy

Conic section traveling ultrasonic motor with high speed and efficiency

Design of Ultrasonic Machining Device for Thin-Wall Cylinder of Air Compressor

Design and Implementation of a Novel Single-Driven Ultrasonic Elliptical Vibration Assisted Cutting Device

Design of the Ultrasonic Atomizing Nozzle’s Vibration System Based on a Piecewise Approximate Method

Design and Analysis of Ultrasonic Composite Transducer with a Quarter-wave Taper Transition Horn

Four-terminal network designing method of ultrasonic vibration system and its applications

A High-Power Linear Ultrasonic Motor Using Bending Vibration Transducer

Design and Experiment Study of Ultrasonic Longitudinal-Torsional Compound Consolidation Vibration System for Metal Foil

Research On A New Composite Ultrasonic Energy Transmission System With The Serial Structure

Innovative Design and Analysis of a Longitudinal-Torsional Transducer with the Shared Node Plane Applied for Ultrasonic Assisted Milling

Design and Experimental Study of Ultrasonic Vibration Feeding Device with Double Symmetrical Structure

Study on Modeling and Simulation of Wire Vibration in WEDM

Design of Ultrasonic Transducer with a Quarter Wavelength Composite Exponential Horn

Design and experimental study of longitudinal-torsional ultrasonic transducer with helical slots considering the stiffness variation

Development of A Two-Dimensional Ultrasonic Vibration Assisted Machining Technology with Tool Vibration

Structure Design Method of Bar-Structure Linear Ultrasonic Motors