Abstract:The green wave coordinated control model has evolved from the basic bandwidth maximization model to the multiweight approach to an asymmetrical multiband model and a general signal progression model with phase optimization to improve the operational efficiency of urban arterial roads and reduce driving delays and the amount of exhaust gas generated by vehicles queuing at intersections. However, most of the existing green wave models of arterial roads are based on a single phase pattern and little consider the optimization of the combination of multiple phase patterns. Initial queue clearing time is also considered at the green wave progression line in the time–space diagram, which leads to a waste of green light time. This study proposes a coordination control optimization method based on an asymmetrical multiband model with phase optimization to address the abovementioned problem. This model optimizes four aspects in the time–distance diagram: phase pattern selection, phase sequence, offset, and queue clearing time. Numerical experiments were conducted using the VISSIM micro traffic simulation tool for intersections along Kunlunshan South Road in Qingdao, and the effect of green wave coordination was evaluated using hierarchical analysis and compared with the signal-timing schemes generated by the four models: the multiweight approach, the improved multiweight approach, an asymmetrical multiband model, and a general signal progression model with phase optimization. The results show that an asymmetrical multiband model with phase optimization obtains a total bandwidth of 314 s in both directions. In the outbound direction, average number of stops, average travel speed, average travel time, and average delay time improve by 16%, 7.9%, 17.9%, and 15.6%, respectively. In the inbound direction, they improve by 43.7%, 16.1%, 40.7%, and 36%, respectively. Polluting gas emissions and fuel consumption improve by 17.9%. The applicability of the optimization method under different traffic flow conditions is analyzed, and results indicate a clear control effect when the traffic volume is moderate and the turning vehicles on the feeder roads are few. This work can provide a reference for the optimization of subsequent arterial signal coordination and also has indirect significance for environmental protection to a certain extent.

Signal optimization and coordination for bus progression based on MAXBAND

A Green Wave Band Based Method for Urban Arterial Signal Control

A Two-Way Arterial Signal Coordination Method with Queueing Process Considered

A Method for Signal Coordination in Large-Scale Urban Road Networks

Bus signal priority method at arterial signal progression

Multiple-Phase Bus Signal Priority Strategy for Arterial Coordination Intersection

A Signal Coordination Model for Long Arterials Considering Link Traffic Flow Characteristics

Proactive Coordination of Traffic Guidance and Signal Control for a Divergent Network

Multi-phase bus signal priority strategy at isolated intersections

System Partition of Urban Arterials Based on Bandwidth Maximization

Incorporating bus delay minimization in design of signal progression for arterials accommodating heavy mixed-traffic flows

Signal Coordination Models for Long Arterials and Grid Networks

Bandwidth Optimisation and Parameter Analysis at Two Adjacent Intersections Based on Set Operations

Signal Timing Optimization Model Based on Bus Priority.

Development and Evaluation of a Passive Bus Signal Priority Algorithm at Isolated Intersection

Study on Signal Timing Methods of Optimizing Urban Transportation Network Efficiency

Collaborative optimization of intersection signals and speed guidance for buses run on overlapping route segments under connected environment

Arterial Coordination Control Optimization Based on AM–BAND–PBAND Model

A synchronization-constraints-based dual bands method of traffic signal optimization

Multi-agent Fuzzy Signal Control with Bus Priority

Integrated Robust Optimization of Scheduling and Signal Timing for Bus Rapid Transit