Abstract:Proceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy, Ahead of Print. In order to figure out the influence of water film on the performance of the turbomachinery, understand the mechanism of the interaction between the high-speed airflow and the water film in turbomachinery, and provide a reference for the design of the subsequent experiments and hollow stationary blade water removal by heating. The commercial software FLUENT with the Eulerian Wall Films model is used to establish a solution method for simulating the flow of water film on the blade. The accuracy of the solution method is verified by comparing it with the results of the water film thickness experiment on the surface of the plate. The distribution of the water film on the outer surface of the vane as well as the influence of the water film on the mainstream field are numerically studied in the condition of the wet steam mainstream. The results show that the gradient of water film thickness on the pressure surface is relatively gentle and is along the radial direction. The gradient of water film thickness on the suction side is along the axial direction, and the value is larger; There is a V-shaped water film agglomeration area on the suction surface near the trailing edge where the water film thickness is greater than 45.7 μm; The top areas on both the suction side and pressure side produce a local water film agglomeration area with the dual effect of the secondary flow and the centrifugal force of the mainstream; The water film flow on the blade surface has little influence of the steam velocity and the speed of the mainstream. The increase of local pressure on the surface leads to an increase in the pressure of the adjacent mainstream areas.

A new boundary layer equation and its application to the flow in turbo‐machinery

Optimization Design of a Turbine Blade to Reduce Secondary Flow Loss Using a Viscous Adjoint Method

Boundary Shape Control of Navier-Stokes Equations and Geometrical Design Method for Blade's Surface in the Impeller

Boundary Shape Control of the Navier-Stokes Equations and Applications

Geometrical design of blade＇s surface and boundary control of Navier-Stokes equations

A Method for Calculating Axial Turbomachine End Wall Turbulent Boundary Layers

A New Boundary Layer Equation and Its Applications to the Shape Optimal Control

Bem/Fdm Conjugate Heat Transfer Analysis of A Two-Dimensional Air-Cooled Turbine Blade Boundary Layer

The Boundary Layer Equations and a Dimensional Split Method for Navier-Stokes Equations in Exterior Domain of a Spheroid and Ellipsoid

VISCOUS THREE-DIMENSIONAL FLOW SOLVERS USED IN MULTISTAGE TURBINE

On the Relation between Blade Loading and In-Passage Energy Balance

Optimal Shape Design for Blade's Surface of an Impeller Via the Navier–Stokes Equations

Numerical study on the three-dimensional flow of water film on the outer surface of the hollow stationary blade

Investigation of the Dihedral Angle Effect on the Boundary Layer Development Using Special-Shaped Expansion Pipes

General Boundary Element Method For Nonlinear Problems In Fluid Mechanics

Blade Geometry Optimization For Axial Flow Compressor

Boundary vorticity flux and engineering flow management

Calculation of Three-Dimensional Transonic Flows in Turbomachinery with Generalized Von Mises Corrdinate System

A boundary surrogate model for micro/nano grooved surface structure applied in turbulence flow control over airfoil

Three-dimensional Euler Solutions for Interior Flow of the Runner Using in the Three Gorges

A Novel Variational Method for 3D Viscous Flow in Flow Channel of Turbomachines Based on Differential Geometry