Abstract:The atomic data of middle and high-Z elements, such as electron-impact ionization and excitation cross-sections, find extensive applications in fields such as fusion science and X-ray interactions with matter. There are atoms and ions in high energy density plasma with different charge states and energy states from ground states to highly excited states, and the cross-sections of each charge state and energy state need to be calculated. The bottleneck limiting computational performance is the unavoidable relativistic effects of middle to high-Z atoms and the incredibly complex electronic configurations. Taking tantalum (Ta) as an example, by using the relativistic Dirac-Fock theory and distorted wave model, we computed the electron-impact ionization and excitation cross-sections of Ta from the ground state atom up to Ta 72+ with the incident electron energy range of 0-150keV. The detailed configuration accounting (DCA) reaction channel cross-sections are derived by summing and weighting the original detailed level accounting (DLA) cross-sections. After examining the data, two regularities are found. In terms of DLA, the pre-averaging DCA cross-sections have varying initial DLA energy levels but are typically close to one another, but there isn't a straightforward function that can explain the discrepancies between them. In terms of DCA, inner subshells typically contribute very little to the total cross-section as their ionization and excitation cross-sections are orders of magnitude smaller than those of outer subshells. We provide two techniques to reduce the computational costs based on the regularities. To minimize the overall number of DLA reaction channels used in the computation, the initial DLA energy levels can be randomly sampled. Through a Monte Carlo numerical experiment, we determine the appropriate number of sampling points that can reduce the total number of DLA channels by an order of magnitude while maintaining a 5% error margin. In terms of impact ionization, since small cross-section DCA channels are insignificant, only a tiny portion of the DCA channels are required to preserve a 95% accuracy of the entire cross-section. It is possible to use the analytical Binary Encounter Bethe (BEB) formula to determine which DCA channels should be neglected before the computation to reduce computational costs. In terms of electron-impact excitation, just the cross-sections of the same excited subshells as the preserved ionized subshells, which are determined in the previous electron-impact ionization (EII) calculation, are needed. Lastly, we compared our EII results with theoretical and experimental results. In the low incident electron energy range of below 2 keV, our results agree with the theoretical result of the 6s EII cross-section of the Ta atom and the experimental result of the total EII cross-section of the Ta 1+ ion. In the high energy range of below 150 keV, our results are also consistent with the theoretical results of the 1s EII cross-section of the Ta atom and the experimental result of the 1s EII cross-section of the Cu atom. Our results reasonably matched the previous experiment and theoretical results in both low and high energy ranges, inner and outer subshells, indicating the accuracy of our calculation. The proposed optimizing strategy can be applied to various middle to high-Z elements and is compatible to most computation codes.

K and L-shell X-ray production cross sections for 50–250keV proton impact on elements with Z =26–30

Study of K-X rays from Different Thick Metal Targets Induced by Helium-like C Ions

Measurement of nuclide production cross sections for GeV-region proton-induced reactions on nat Mg, nat Si, nat Fe, nat Cu, and nat Zn

Cross sections for the production of radionuclides induced in W targets by high energy carbon ions and protons

Correction of Substrate Effect in the Measurement of 8-25-kev Electron-Impact K-Shell Ionization Cross Sections of Cu and Co Elements

L shell x-ray production in high-Z elements using 4-6 MeV/u fluorine ions

Electron Impact Ionization Cross Sections of Highly Charged Open L-shell Tungsten Ions

Inner-shell ionization cross sections of atoms by positron impact

Empirical calculation of K-shell fluorescence cross sections for elements in the atomic range 16≤Z≤92 by photon effects ranging from 5.46 to 123.6 keV (Three-dimensional formulae)

Cross Sections of Proton- and Neutron-Induced Reactions by the Liège Intranuclear Cascade Model

Measurement of Reaction Cross Section for Proton-Rich Nuclei (A < 30) at Intermediate Energies

A Fast Computation Approach of Electron-Impact Ionization and Excitation Cross-sections for Atoms and Ions of Middle and High-Z Elements

Spallation and fragmentation cross sections for 168 MeV/nucleon Xe136 ions on proton, deuteron, and carbon targets

Experimental Study of the Exotic-Nuclei

Measurement and Validation of the Cross Section in the FLUKA Code for the Production of 63 Zn and 65 Zn in Cu Targets for Low-Energy Proton Accelerators

Impact parameter moments for ionization of Ne, Ar, Kr, and Xe by protons, considering different initial states and impact energies

PROJECTILE FRAGMENTATION OF36,40Ar INDUCED REACTIONS

Production Cross Sections of 102mrh and 108mag in Proton Bombed Natpb Target with 400 MeV Energy

Production Cross Section of Superheavy Nuclei in Cold Fusion Reactions Based on the Relativistic Mean Field Theory

Cross sections of theFe56(n,α)Cr53andFe54(n,α)Cr51reactions in the MeV region

Measurements of Total Reaction Cross Sections for Some Light Nuclei Atintermediate Energies