Abstract:Glucose detection with small and micro volume sampling has recently received increasing attention in monitoring personal health. Herein, a cauliflower-type cluster of Cu2O nanoparticles (NPs) was directly deposited on the tip surface of a stainless steel acupuncture needle electrode (ANE) by electrochemical deposition, and then this pre-formed cuprous basis was used to further prepare the neatly arranged CoCu-layered double hydroxide (CoCu-LDH) nanosheets that interconnected to form nano-sized pores in the range from 100 to 500 nm. The microstructure and spectral characteristics of the surface modification materials were comprehensively characterized by FE-SEM, EDS, XRD, FT-IR and TEM. Cu2O-based CoCu-LDH composites with special morphology had been proven to accelerate the rate of electron transport and provide more available active centers, and moreover, the mixed valence of Cu/Co induced an excellent synergism for the electrocatalytic oxidation of glucose. As a result, CoCu-LDH/Cu2O/ANE as a sensitive glucose probe exhibited two wider linear ranges of 0.03-0.40 mM and 0.40-6.00 mM, with sensitivities of 116.13 μA mM-1 and 52.08 μA mM-1, respectively, and the detection limit as low as 0.46 μM (S/N = 3). The response time only took 3 s and it kept working stably in the interference of ascorbic acid (AA), dopamine (DA), uric acid (UA), and Cl-. In the stability test, the CoCu-LDH/Cu2O/ANE sensor exhibited a stable monitoring sensitivity after 15 days. Finally, the CoCu-LDH/Cu2O/ANE sensor had been successfully applied to glucose analysis in human serum, proving that our design was an attractive strategy for developing a portable, minimally invasive, and low-cost non-enzymatic electrochemical glucose sensing platform.

A Non-Enzymatic Glucose Amperometric Biosensor Based on a Simple One-Step Electrodeposition of Cu Microdendrites Onto Single-Walled Carbon Nanohorn-Modified Electrode

A Highly Sensitive Nonenzymatic Glucose Sensor Based on Cu/Cu2O Composite Nanoparticles Decorated Single Carbon Fiber

A non-enzymatic glucose sensor based on electrodepositing Cu/graphene nanocomposite film modified electrode

Copper Nanoparticle/Graphene Oxide/Single Wall Carbon Nanotube Hybrid Materials As Electrochemical Sensing Platform for Nonenzymatic Glucose Detection

Direct Decoration of Carbon Nanohorns with Binary Nickel-Cobalt Sulfide Nanosheets Towards Non-Enzymatic Glucose Sensing in Human Fluids

Construction of a non-enzymatic glucose sensor based on copper nanoparticles/poly( o -phenylenediamine) nanocomposites

A highly sensitive non-enzymatic glucose sensor based on CuNi nanoalloys through one-step electrodeposition strategy

In-situ synthesis of metasequoia-leaf-like Cu/Cu 2 O/Ni(OH) 2 on a glassy carbon electrode for efficient non-enzymatic glucose sensing

Non-enzymatic Amperometric Glucose Sensor Based on Copper Nanowires Decorated Reduced Graphene Oxide

An efficient biosensor using a functionalized microneedle of Cu2O-based CoCu-LDH for glucose detection

Glucose biosensors based on nano-composites of multi-walled carbon nanotubes and zinc oxide nanorods

A Non-Enzymatic Glucose Sensing Based on Hollow Cuprous Oxide Nanospheres in A Nafion Matrix

Novel Phosphomolybdic Acid/single-Walled Carbon Nanohorn-Based Modified Electrode for Non-Enzyme Glucose Sensing

Non-Enzymatic Amperometric Determination of Glucose by CuO Nanobelt Graphene Composite Modified Glassy Carbon Electrode

One-Dimensional Copper Oxide Nanoparticles Embedded Conductive Nanotube Arrays for High Performance Glucose Sensors

A Biocompatible, Highly Sensitive, and Non-Enzymatic Glucose Electrochemical Sensor Based on a Copper-Cysteamine (Cu-Cy)/Chitosan-Modified Electrode

High-performance non-enzymatic glucose sensor based on flower-like Cu2O-Cu-Au ternary nanocomposites

Photodiode-based cutting interruption sensor for near-infrared lasers.

Nonenzymatic glucose sensor based on nickel(II)oxide/ordered mesoporous carbon modified glassy carbon electrode

One-pot synthesis of uniform Cu nanowires and their enhanced non-enzymatic glucose sensor performance

Non-enzymatic glucose sensors based on electrodeposited CuxO–ZnO composite nanostructures