Abstract:The purpose of this article is to analyze the front door coupling effect that may occur in the projectile receiver due to the discharge pulse radiation in electromagnetic railguns, and to simulate the discharge pulse interference. This phenomenon will have an impact on the launch of the projectile, causing its fuse to be disturbed, ultimately affecting the weapon performance of the electromagnetic railgun. Discharge refers to when the armature carrying the projectile is fired out of the chamber, and the armature connected between the two rails detaches, causing a circuit break in the electrical circuit during the operation of the electromagnetic railgun. The current flowing through the armature is disturbed, causing an instantaneous high voltage to penetrate the air gap between the two rails, generating nanosecond pulse width discharge voltage pulse radiation, with a spectrum of up to tens of megahertz. In this paper, we establish a receiving antenna model on the projectile, which is essentially a horn antenna, receiving electromagnetic pulses from the discharge process, and coupling the pulse interference through its front door. During the analysis and calculation, we established an antenna receiver model located in the C-band with a frequency of 6 GHz for simulation, analyzed and calculated the actual interference loaded on the projectile after front door coupling, and verified the correctness of the simulation settings and results by comparing with the literature. Finally, we found that because the main energy spectrum of the pulse is at MHz level, when the front door of the C-band horn antenna is coupled, the standing wave ratio of the antenna is very large and the gain is very small, so the pulse interference is filtered, which can make the interference finally loaded on the projectile insufficient to affect the normal operation of the projectile. At the same time, it is recommended to add an RF filter to the receiving channel to further enhance anti-interference ability, so as to ultimately enable the electromagnetic railgun to function properly.

Research and Progress of Electromagnetic Coil Gun Ranging

Design and Characterization of High Efficiency Single-stage Electromagnetic Coil Guns

Research on Position Trigger Control of Multistage Electromagnetic Coil Launcher

Optimal Trigger Position of Multi-Stage Inductive Coilgun with Armature Velocity

In-Bore Dynamic Measurement and Mechanism Analysis of Multi-Physics Environment for Electromagnetic Railguns

Data Processing Approaches to Measure Velocity of Electromagnetic Gun on Laser Screen in Complex Environment

Analysis of the Research Progress of Electromagnetic Railgun Based on CiteSpace

Multi-parameters study on underwater coil launch

Research on the Control Strategy of Multistage Synchronous Inductive Coil Launcher

A Missile-Borne Angular Velocity Sensor Based on Triaxial Electromagnetic Induction Coils

Coil Position Control Technology in Magnetic Coupled Wireless Power Transmission

Detecting Malposition of Coil-Couple for Transcutaneous Energy Transmission.

Electromagnetic field analysis and modeling of a relative position detection sensor for high speed maglev trains

Serial-charge-parallel-discharge inductive energy supply for coilgun system

Triggering Strategy of Railgun Power Supply for the Accurate Control of the Armature Muzzle Velocity

Control and trigger strategy of multi-stage synchronous inductive coil launcher

Investigation of the Distribution Problem in the Operating State of an Electromagnetic Railgun: Radio Fuse Disturbance, Field Characteristics, and Susceptible

Modeling and Parameter Optimization of Coilgun System with Inductive Energy Storage Supply

Preliminary Analysis on Muzzle Velocity Measurement in Electromagnetic Launch

[Research Progress in Electromagnetic Tracking Method].

Research on Interior Ballistic Mechanics of Electromagnetic Railgun