Abstract:In the present work, two model alloy systems which were NiCr (0Fe) and NiCrFe (15Fe) alloys with different phosphorus (P) contents were prepared and subjected to the same heat treatment. The influence of P on microstructures and 650 °C tensile properties in two model alloys was investigated. The results showed that the precipitation of intergranular α-Cr phases was inhibited by the addition of P and the addition of Fe made α-Cr phases tend to precipitate in granular form rather than lamellar form at grain boundaries. Meanwhile, the increase of P content promoted the grain growth for 0Fe alloys while had little effect for 15Fe alloys, and the proportion of Σ3 grain boundaries of the two model alloys both decreased with the increase of P content. The 650 °C yield and tensile strength of 0Fe alloys showed a faster decreasing trend with increasing the P content while the elongation both increased significantly. The main grain boundary strengthening mechanism gradually changed from the pinning effect of α-Cr phases to the Σ3 grain boundary strengthening and P atoms segregation strengthening with increasing the P content. Thus, the fracture mode transformed from single intergranular fracture to mixture of transgranular and intergranular fracture with the increase of P content. In addition, the intragranular strengthening effect of Fe and P also contributed to the strength of 15Fe alloys, which reduced the decline rate of tensile strength.

Effect of Annealing Temperature on Phosphorus Segregation at Grain Boundary in A Ti-If Steel

Phosphorus Segregation Behavior at the Grain Boundary in a Ti-IF Steel after Annealing

Effect of Phosphorus Contents on Texture and Grain Boundary Character for the Annealing High Strength Ti-IF Steels

Non-Equilibrium Grain Boundary Segregation of Phosphorus under A High Applied Tensile Stress in A 2.25cr1mo Steel

Fractographic Changes Caused by Phosphorus Grain Boundary Segregation for A Low Alloy Structural Steel

An Auger Electron Spectroscopy Study of Phosphorus and Molybdenum Grain Boundary Segregation in a 2.25cr1mo Steel

Phosphorus Grain Boundary Segregation under an Intermediate Applied Tensile Stress in a Cr–Mo Low Alloy Steel

Equilibrium segregation of phosphorus at grain boundaries of Fe–P, Fe–C–P, Fe–Cr–P, and Fe–Cr–C–P alloys

Stress-induced Non-Equilibrium Grain Boundary Segregation of Phosphorus in a Cr–Mo Low Alloy Steel

Phosphorus Grain Boundary Segregation under Different Applied Tensile Stress Levels in a Cr–Mo Low Alloy Steel

Grain boundary character dependence of phosphorus segregation at ferrite grain boundaries in a high-purity iron-phosphorus binary alloy

Grain boundary nanochemistry and intergranular corrosion of Fe-0.01wt.%P alloy: Roles of elemental segregations and misorientation

Effect of Annealing Temperature on the Microstructure and Properties of the TWIP Steel with Low Silicon and Aluminum

Effect of Silicon Addition on Phosphorus Segregation at Grain Boundary and Temper Embrittlement of Fe-C-Mn-xSi Steels

Effects of annealing heat treatment on grain boundary orientation differential evolution of TA15 alloy

Non-Equilibrium Segregation of Phosphorus at Grain Boundaries during Step Cooling

Experimental Study on Kinetics of Non-Equilibrium Grain-Boundary Segregation of Phosphorus in 12Cr1MoV Steel

Effects of P on microstructures and tensile properties in Ni17Cr and Ni17Cr15Fe model alloys

Interface segregation behavior in thermal aged austenitic precipitation strengthened stainless steel

Quantitative compositional analysis of P segregation to grain boundaries in steel by use of EDS and EELS

Effect of Annealing Temperature on the Surface and Subsurface Microstructure of Al-added TWIP Steel