Abstract:In artificial freezing engineering, the freezing temperature is an important factor affecting soil frost heave deformation, and studying its impact is of great significance. The frost heave ratio of soil is a crucial factor for designing and predicting soil frost heave. However, it only considers vertical deformation while neglecting radial deformation. This paper introduces a simple unidirectional freezing apparatus specifically designed for three-dimensional X-ray computed tomography (CT) scanning, which allows for the investigation of internal structural changes in clay during freezing at four different freezing temperatures (i.e., -3 oC, -5 oC, -7 oC, and -9 oC). Freeze-necking of the soil was observed during freezing. An image processing method was proposed to segment the soil samples, and parameters such as length, equivalent diameter, and volume were measured to assess changes during freezing. The observed variations in necking depth and equivalent diameter indicate that freeze-necking is uniform. As the freezing temperature decreased, the necking depth reduced from 72.4 mm to 38.1 mm, and within this necking depth, the equivalent diameter decreased progressively from the bottom to the top. Moisture content increased near the cold end of the soil and decreased near the warm end, suggesting that freeze-necking is due to moisture migration within the soil. Considering freeze-necking, the volumetric frost heave ratio was defined to characterize soil frost heave deformation. This ratio also decreases as the freezing temperature decreases, and the values are smaller than those of the traditional frost heave ratio. The discrepancies become more pronounced at higher freezing temperatures, reaching up to 1.8% at -3 °C. The results indicate that lower freezing temperatures can reduce frost heave deformation, and freeze-necking requires greater attention in engineering at higher freezing temperature.

Experimental Study on the Influence of Different Cooling Rate to Frost Heave of Silty Clay

Effect of Different Moisture Content on Mechanical Parameters of Red Clay Under Freeze-Thaw Cycle

Experimental Research on Frost Heaving and Moiture Changing with a Type of Silty Clay

Experimental Study on Frost Heaving Behavior of Soil under Different Loading Paths

Experimental Study on the Effect of Initial Water Content and Temperature Gradient on Soil Column Segregation Frost Heave

A systematic investigation of the freezing process of silty clay through unidirectional stepwise freezing method combined with digital imaging processing technology

Experimental study on frost heave characteristics and micro-mechanism of fine-grained soil in seasonally frozen regions

Effect of Temperature on the Strength Characteristics of Unsaturated Silty Clay in Seasonal Frozen Region

The Study of Influence of Freeze-Thaw Cycles on Silty Sand in Seasonally Frozen Soil Regions

Experimental study on the water and heat dynamic characteristics of silty clay at different depths under temperature gradient

Frost Heave in Coarse-grained Soils: Experimental Evidence and Numerical modelling

Experimental Investigation on Triaxial Frost Heaving Stress-Strain Relationship of Saturated Clay

Cyclic Freeze–thaw Induced Stiffness Anisotropy of Sandy Silt under All-Round and Unidirectional Freezing Modes

The Modelling of Freezing Process in Saturated Soil Based on the Thermal-Hydro-Mechanical Multi-Physics Field Coupling Theory

Simulation of heat–water–mechanics process in a freezing soil under stepwise freezing

Freeze-necking and volumetric change of clay during freezing by 3D X-ray Computed Tomography

Effect of dynamic load and cooling path on the frost characteristics of saturated lean clay

Experimental study on the effect of freeze-thaw cycles on the shear characteristics of frozen soil-composite geotextile interface

Study of the Mechanical and Microscopic Properties of Modified Silty Clay under Freeze-Thaw Cycles

Thermal-hydraulic-mechanical coupling behavior and frost heave mitigation in freezing soil

Experimental study of the freeze thaw characteristics of expansive soil slope models with different initial moisture contents