Abstract:Interest in the construction of prefabricated ice rink for international competition has increased in recent years, where the ice sheet is directly supported by soft thermal insulation materials. However, bending failure in the ice sheets for these rinks is highly possible because of different compression and tension behaviors. Moreover, the mechanical behaviors of the artificial ice produced layer-by-layer in rinks remain unclear. Therefore, microstructure observations, hardness tests, and three-point bending tests were conducted in this study to better understand artificial ice. First, the crystal structures were obtained through observations in both the vertical and horizontal directions. Then, the hardness of the ice surface at different temperatures, water qualities, ice-making methods, and surrounding environmental conditions was measured using the Shore hardness apparatus. Finally, systematic three-point bending tests on 80 effective ice specimens under a wide range of loading and ice-making parameters were performed. The results show that artificial ice is a typical kind of columnar ice with smaller grain sizes at lower surfaces. The ice surface hardness, roughly normally distributed, was mainly affected by temperature and ice-making mode. Moreover, it was found that all the test ice beam exhibited brittle fracture, and the flexural strength ranged from 0.84 to 2.47 MPa, with the maximum average at a strain rate of 1 × 10–4 s–1. Based on these test results, empirical functions for the effects of the investigated parameters on the flexural strength and effective modulus were developed. Also, the relationships between flexural and tensile strength for artificial ice were established using Weibull law and the coupled criterion. In addition, the linear regression model was established and verified using different prediction methods to predict the ice flexural behavior in practical rinks based on the measured hardness in a simple, reliable, and nondestructive way. The current experiment and analysis are beneficial for the design, operation and maintenance of prefabricated ice rinks.

Laboratory Investigation on Mechanical Behavior of Artificial Ice under Triaxial Compression

Experimental Technique for Ice under Dynamic Compressive Loading

The Experimental Investigations of the Deep Artificially Permafrost Constitutive Character

Uniaxial Compressive Strength and Fracture Mode of Lake Ice at Moderate Strain Rates Based on a Digital Speckle Correlation Method for Deformation Measurement

The Influence of Pressure-Shift Freezing Based on the Supercooling and Pressure Parameters on the Freshwater Surimi Gel Characteristics

Experimental and Numerical Study of the Uniaxial Compressive Strength of Ice with Initial Fibrous Pore: Effects of Temperature and Loading Rate

Modeling and Mesoscale Simulation of Ice-Strengthened Mechanical Properties of Concrete at Low Temperatures

Experimental investigation on mechanical properties and failure mechanism of rock-like specimens containing an arc-shaped ice-filled flaw under uniaxial compression

Flexural characteristics of artificial ice in winter sports rinks: experimental study and nondestructive prediction based on surface hardness method

Experimental Investigation of the Deformational Behavior of the Interfacial Transition Zone (itz) in Concrete During Freezing and Thawing Cycles

Mechanical performances of rock-concrete bi-material disks under diametrical compression

Stress Analysis for Concrete Materials under Multiple Freeze-Thaw Cycles

Influence of freezing temperature and cotton content of ice on dynamic mechanical properties and energy dissipation

Numerical modeling for strain rate effect and size effect of ice under uniaxial tension and compression

Effect of freeze–thaw cycles on the stress–strain curves of unconfined and confined concrete

Mechanical properties of bi- and poly-crystalline ice

REPEATED COMPRESSION-ANNEALING EXPERIMENTS ON ANISOTROPIC CORE ICE

Behavior of Concrete Under the Triaxial Compression

Influence of intermediate principal stress on the strength and deformation behavior of artificial frozen sand

Observation of crack arrest in ice by high aspect ratio particles during uniaxial compression

Study on the Ice Friction Characteristics