Abstract:The effect of preparation conditions such as sintering temperature on the luminescence properties of SrTiO_3∶Pr~(3+) phosphors doped by compensation ions with various valences were studied to obtain best luminescence property. The doping ions with various valences were selected to verify the charge compensation effect on the luminescence intensity as K and Al seem to have similar charge compensation effect. PL spectra were measured to analyze the effect of preparation parameters, such as doping ions of K, Ca, Al and sintering (temperature,) on the luminescence properties of SrTiO_3∶Pr~(3+) phosphors. And XRD measurements were carried out to verify the crystal structure of prepared SrTiO_3∶Pr~(3+) phosphors. The results revealed that all samples emit red light at 610 nm originating from ~1D_2→~3H_4 transition of Pr~(3+) (ions.) The luminescence intensity varies with sintering temperature, while the samples sintered at 1 150 ℃ have the best luminescence intensity. Among K, Ca and Al doped samples, only the Al-doped samples have the (obvious) enhanced luminescence intensity, the strongest luminescence intensity was about 10 times as that of pure SrTiO_3∶Pr~(3+) phosphor without compensation doping. On the other hand, phosphor doped with K ions, which likely has similar charge compensation effect as that doped with Al ions, has little effect on the improvement of luminescence intensity. Contrary, it has similar intensity as that of either pure SrTiO_3∶Pr~(3+) phosphors or Ca-doped phosphors which are believed to have not such charge compensation effect. Above result about the effect of various ions doping on luminescence properties could be explained by combination of charge compensation effect and substitution structure effect. The charge compensation effect is effective only when the doping ions Al~(3+) is substitute for the Ti ions which is the nearest neighbor ion to the (luminescence) ions of Pr~+_(Sr). Present study shows an optimal preparation condition and proposes a method to choose effective charge compensation ion for SrTiO_3∶Pr~(3+) phosphors with best luminescence intensity.

Luminescence Characteristics Of Ba0.5sr0.5tio3:Pr-X, Al-Y Powders Synthesized By Citrate-Nitride Combustion Process

Enhancement of Luminescent Properties of Sol-Gel-Derived BaTiO3: Pr

Enhanced Luminescence for Srtio3 : Pr3+ Phosphors with the Addition of Al3+ Ions

Photoluminescence and its Enhancement of Pr<sup>3+</sup>-Doped BaTiO<sub>3</sub> Phosphor

Effect of Sr2+ substitution for equivalent Ca2+ ions on luminescence intensity of CaTiO3 : 0.002Pr(3+)

Effect of Compensation Ions and Sintering Temperature on the Luminescence Properties of SrTiO_3∶0.002Pr~(3+) Phosphor

Preperation and Photoluminescent Properties of Ca2AlSi3O2N5:Sm3+ Phosphor

Energy Transfer in Pr3+ and Mn2+ Co-Doped SrB6O10 and SrB4O7

White Luminescence of Tm–Dy Ions Co-Doped Aluminoborosilicate Glasses under UV Light Excitation

Photoluminescence effects and probing phase transition of Sm3+-doped Ba(Ti0.8Hf0.2)O3-(Ba0.7Ca0.3)TiO3 phosphor prepared by hydrothermal method

Synthesis of Ce3+and Pr3+-Codoped SrTiO3 and Its Luminescence Properties by Sol-Gel Route

Effect of Sm3+ co-doping on the luminescence behavior of Pr3+-activated Sr3Al2O6 orange-reddish phosphors

Preparation and luminescence properties of Ce3+ and Tb 3+ co-doped glasses and glass ceramics containing SrF2 nanocrystals

Luminescent Properties of Pr3+ Doped (ca, Zn) TiO3: Powders and Films

Photoluminescence and afterglow behavior of orange-reddish Pr3+-activated Sr3Al2O6 phosphor

Synthesis and Red Luminescence of Pr3+-doped CaTiO3 Nanophosphor from Polymer Precursor

Luminescent property of Pr3+ in SrB4O7

Luminescence Behavior and Structural Characteristics of Novel BaYAl3O7: Tb3+ Nanophosphors

Luminescence and microstructural characteristics of Eu2O3-doped SrAl2O4 single crystals

Photoluminescence and Electrical Properties of SrSmAlO4-doped (bi0.5na0.5)0.935ba0.065tio3 Ferroelectric Ceramics

Synthesis and Luminescent Properties of Pr-Doped Lu3al5o12 Translucent Ceramic