Abstract:The separation of the gas and liquid in the gas-liquid cyclone separator is achieved through the swirling flow. The liquid film flow characteristics and the dynamics of droplets impacting the liquid film are very important for the separation performance, but these phenomena have not been well understood in the swirling flow. In this work, an experiment was conducted to investigate the liquid film flow and droplet impingement in the annular channel of the gas-liquid cyclone separator. Three regions of the annular channel could be divided based on the film flow patterns, which were the inlet region, the annular region, and the outlet region; and four typical droplet impact outcomes could be observed, which were splashing, coalescence, bouncing, and jet breakup. According to the characteristics of the liquid film and the outcome of droplet liquid film impingement, if the droplet splashing in the inlet region could be weakened and the length of the annular region was lengthened, it would be beneficial for gas-liquid separation. The impact outcomes were shown to undergo a transition from bouncing to coalescence as the droplet Weber number increased. Droplet coalescence was affected by the disturbance of gas flow and the evenness of the liquid film, so when the superficial velocity of the gas flow was fixed, the transition boundary was constant whatever the liquid volume fraction in the channel, and when the Reynolds number of the gas flow increased, the transition boundary of droplet Weber number increased first and then decreased. This work may provide a basis for a comprehensive understanding of the liquid film flow pattern and droplet behavior in the cyclone separator, and the results have the potential to be applied in other multiphase studies.

Experimental Study of Oil-Gas Cyclone Separator Performance in Oil-Injection Compressor System

Numerical and Experimental Investigations of the Effects of the Breakup of Oil Droplets on the Performance of Oil–gas Cyclone Separators in Oil-Injected Compressor Systems

Research on the Two-Phase Flow and Separation Mechanism in the Oil-Gas Cyclone Separator

An experimental investigation of the oil film distribution in an oil–gas cyclone separator

Theoretical Modeling of the Oil–Gas Cyclone Separator in Oil–Injected Compressor Systems

Experimental study on the separation performance of a novel oil–gas cyclone separator

Performance Evaluation of a New Micro Gas Cyclone Using Simulation and Experimental Studies to Capture Indoor Fine Particles

Experimental Study and Numerical Simulation of the Characteristics of a Percussive Gas–solid Separator

Investigation of the oil–gas separation in a horizontal separator for oil-injected compressor units

Separation performance of hydrocyclone oil removal device influenced by oil droplet trajectory and oil drop characteristics

Experimental Investigation of Oil Film Flow and Droplets Behavior in the Annular Channel of a Cyclone Separator

Investigation of Separation Efficiency in Centrifugal Oil-Air Separator Based on CFD

Experimental investigation on separation characteristics of axial cyclone separator

Performance Investigation and Optimization of the Primary Separation Part of the Oil-Gas Separator

Effects of different oil return pipe locations on the vortex characteristics of a cylindrical cyclone separator

Design for separation efficiency test stand of oil separator used in compressors

Design and performance study of a two-stage inline gas-liquid cyclone separator with large range of inlet gas volume fraction

Experimental Investigation on the Separation Characteristics of the Novel Combined Separator

Numerical Simulation Study on Separation Performance of Cyclone Separator Based on Fluent

Experimental study on the separation performance of a novel gas–liquid separator

Study on Performance of Dynamic Pressure Oil-Gas Separator Using Bubble Trajectory Model