Abstract:A series of narrow band-gap conjugated copolymers (PFO-DDQ) derived from 9,9-dioctylfluorene (DOF) and 2,3-dimethyl-5,8-dithien-2-yl-quinoxalines (DDQ) is prepared by the palladium-catalyzed Suzuki coupling reaction with the molar feed ratio of DDQ at around 1%, 5%, 15%, 30% and 50%, respectively. The obtained polymers are readily soluble in common organic solvents. The solutions and the thin solid films of the copolymers absorb light from 300–590 nm with two absorbance peaks at around 380 and 490 nm. The intensity of 490 nm peak increases with the increasing DDQ content in the polymers. Efficient energy transfer due to exciton trapping on narrow-band-gap DDQ sites has been observed. The PL emission consists exclusively of DDQ unit emission at around 591–643 nm depending on the DDQ content in solid film. The EL emission peaks are red-shifted from 580 nm for PFO-DDQ1 to 635 nm for PFO-DDQ50. The highest external quantum efficiency achieved with the device configuration ITO/PEDOT/PVK/PFO-DDQ15/Ba/Al is 1.33% with a luminous efficiency 1.54 cd/A. Bulk heterojunction photovoltaic cells fabricated from composite films of PFO-DDQ30 copolymer and [6,6]-phenyl C61 butyric acid methyl ester (PCBM) as electron donor and electron acceptor, respectively in device configuration: ITO/PEDOT:PSS/PFODDQ30: PCBM/PFPNBr/Al shows power conversion efficiencies of 1.18% with open-circuit voltage (V oc) of 0.90 V and short-circuit current density (J sc) of 2.66 mA/cm2 under an AM1.5 solar simulator (100 mW/cm2). The photocurrent response wavelengths of the PVCs based on PFO-DDQ30/PCBM blends covers 300–700 nm. This indicates that these kinds of low band-gap polymers are promising candidates for polymeric solar cells and red light-emitting diodes.

Synthesis and Electroluminescent Properties of Fluorene-Based Three-Component Red Light-Emitting Copolymers

Synthesis and performances of chelating electrophosphorescent polymers based on different ancillary ligands

Green Polarized Electroluminescence from Poly (9, 9-Dioctylfluorene-alt- Benzothiadiazole)

Highly Polarized White-Light Emission from A Single Copolymer Based on Fluorene

Application of Heteroleptic Iridium Complexes with Fluorenyl-Modified 1-Phenylisoquinoline Ligand for High-Efficiency Red Polymer Light-Emitting Devices

FLUORENE-BASED COPOLYMERS FOR RED LIGHT-EMITTING DIODES AND BULK HETEROJUNCTION PHOTOVOLTAIC CELL

Synthesis and Electroluminescent Properties of the Copolymers of Fluorene and Dibenzothiophene

Synthesis, Characterization and Photophysics of Fluorene-Alt-oxadiazole Copolymers Containing Pendent Iridium (III) Complex Moiety

Synthesis and Light-Emitting Properties of Novel Red Electrophosphorescent Fluorene-Alt-Carbazole Copolymers

Novel Red Light-Emitting Polymers Based on 2,7-Carbazole and Thiophene Derivatives

Novel Red Light‐Emitting Fluorene‐alt‐Carbazole Copolymers with Carbazole N‐Graft Cyclometalated Ir Complexes

Monochromatic-Red-Light Emission of Novel Copolymers Containing Carbazole Units and Europium-Acrylate Complexes

Highly Efficient and Stable Blue Polymer Light Emitting Diodes Based on Polysilafluorenes with Pendent Hole Transporting Groups

Conjugated Alternating Copolymers of Fluorene and 2-Pyridine-4-ylidenemalononitrile: Synthesis, Characterization and Electroluminescent Properties

A dithienyl benzotriazole-based polyfluorene: Synthesis and applications in polymer solar cells and red light-emitting diodes

Novel Orange-Red Light-Emitting Polymers with Cyclometaled Iridium Complex Grafted in Alkyl Chain

Synthesis, Characterization, and Electroluminescence of Novel Copolyfluorenes and Their Applications in White Light Emission

Efficient Saturated Red Light-Emitting Polyfluorenes Containing Iridium Complexes in Side Chains

Polyfluorene Derivatives Pending Iridium Complexes: Improved Optoelectronic Properties by Introducing D‐A Units and Altering Pendent Mode

High-efficiency red-light emission from polyfluorenes grafted with cyclometalated iridium complexes and charge transport moiety.

Synthesis, Characterization, and Electroluminescent Properties of a Novel Perylene‐containing Copolyimide