Synthesis and Properties of Dications-Containing Poly(aryl Ether Sulfone) Anion Exchange Membranes
Zhengwang Tao,Chenyi Wang,Chang Xu,Xiaoyan Zhao
DOI: https://doi.org/10.1360/tb-2020-0199
2020-01-01
Abstract:Since the 21st century, energy and environmental issues have become the focus of global attention. Traditional fossil energy resources such as oil and natural gas are drying up. Meanwhile, a large number of harmful gases and other pollutants would be produced in the use of traditional energy, which has a serious damage to the environment and climate. With the rapid increase of energy consumption and the need of environmental protection, the demand for clean and efficient energy is growing. Fuel cell (FC) is considered as one of the most promising energy conversion technologies that can replace conventional fossil fuels, and it is also an important choice in the use of hydrogen, methanol, ethanol and other renewable energy. As a new energy with great potential, FC can reduce the energy crisis and environmental pollution effectively by directly converting the chemical energy of the external input fuel into electrical energy and continuously supplying power to the outside. Ion exchange membrane (IEM) is an important component of FC, which is responsible for transferring ions and forming a complete FC circuit. According to the types of conducting ions, IEM can be divided into proton exchange membrane (PEM) and anion exchange membrane (AEM), which are applied to proton exchange membrane fuel cell (PEMFC) and alkaline anion exchange membrane fuel cell (AAEMFC), respectively. Compared with PEMFC, AAEMFC has the advantages of using non noble metal catalyst, high electrode reaction reactivity, and low fuel purity requirements and so on. However, the commercial AEM with organic cations often has low ionic conductivity and poor alkali and dimensional stability, which seriously hinders its development and application in AAEMFC. Therefore, it is urgent to design and develop new high-performance AEM materials. In order to improve the conductivity, alkali stability and dimensional stability of AEMs, a novel reactive bisphenol monomer with pendant dimethylphenoxybenzene group, 1,1-bis (4-hydroxyphenyl)-1-(4-(3,5-dimethylphenoxy) phenyl) phenyl-2,2,2-trifluoroethane (2), was synthesized based on molecular design using 4-fluoro-2,2,2-trifluoroacetophenone, 3,5-dimethylphenol and phenol as starting materials by a two-step organic reaction. Then, two series of poly(aryl ether sulfone) anion exchange membranes (2-PAES-QA-xx and 2-PAES-Im-xx) with comb structure were prepared through aromatic nucleophilic copolycondensation, bromination and quaternization reaction based on monomer 2. The structures of the active bisphenol monomer, the poly(aryl sulfone) containing methyl groups, the brominated poly(aryl ether sulfone)s and the ionized polymers were characterized systematically by nuclear magnetic resonance spectroscopy, respectively. The water uptake, swelling ratio, ionic conductivity, thermal stability, mechanical properties, and alkaline resistance stability of the prepared 2-PAES-QA-xx and 2-PAES-Im-xx membranes were studied in detail. The relationship between the structure and properties of different types of AEMs is further compared. The obtained AEMs showed good overall performance, and the OH- conductivity of these membranes at 60 degrees C is 35.9-51.6 and 32.6-44.9 mS/cm, respectively. The IEC values of the representative 2-PAES-QA-60 and 2-PAES-Im-60 maintained at 79.7% and 88.5% of the initial values after immersion in 4 mol/L NaOH at 80 degrees C for 336 h, respectively. This work provides a new strategy for the design and preparation of comb-type AEM materials.