Abstract:Compared to traditional, static-based flywheel systems, vehicle-mounted magnetic suspension flywheels face more complex operating conditions, and existing control strategies usually regard disturbances in vehicles under different operating conditions to be the same problem. Therefore, it is necessary to determine the interference from complex operating conditions and reasonably distinguish among them under different operating conditions to provide flywheel systems with strong stability (the rotor offset was less than 0.025 mm). Thus, this paper proposes a high-stability control strategy for flywheels based on the classification of vehicle-driving conditions and designs its control strategy by taking the vehicle-mounted magnetic suspension flywheel with a virtual inertia spindle as an example. First, according to the different vehicle working conditions and the varying interference intensities affecting the flywheel system, the working mode is divided into four modes. Considering the obvious differences in each working mode, it is proposed to use BP neural network optimization based on the simulated annealing algorithm (SA-BPNN) to determine the flywheel's working condition. A relatively simple neural network can improve the response speed of the whole system. It also has a good effect. Secondly, it is proposed to use deep learning models based on convolutional neural networks, long short-term memory networks and attention mechanisms (CNN+LSTM+ATTENTION) to train the corresponding control parameters under each working condition to judge and predict the control parameters under different working conditions. Three evaluation parameters are used to evaluate the training results, and all achieved good results. Finally, the classification of working conditions and performance tests are carried out. The experimental results show the effectiveness and superiority of the proposed control strategy.

Structural Vibration Control of the Magnetic Flywheel Based on Ga-Pid Neural Network

Fuzzy PI Vector Control Design of AC Servo Permanent Magnet Synchronous Motor System

Fuzzy PID Controller Design for a Permanent Magnet Linear Synchronous Motor Feeding System

Control System Design And Implementation Of A Partially-Self-Bearing Flywheel Energy Storage System

Rotor Vibration Control for Magnetic Suspended High-Speed Flywheel Energy Storage System with Inverse System Method and Extended 2-DOF PID Controller

Vibration Control for Active Magnetic Bearing High-Speed Flywheel Rotor System with Modal Separation and Velocity Estimation Strategy

Active Control of Active Magnetic Bearings for Maglev Flywheel Rotor System Based on Sliding Mode Control

Modal decoupling control for active magnetic bearing-supported flywheel rotor system

Research on PID Tuning Method of Magnetically Suspended Rotor System Based on IMC

Decoupling Control for Active Magnetic Bearing High-speed Flywheel Rotor Based on Mode Separation and State Feedback

Vibration of Flexible Rotor Systems with Two-Degree-Of-Freedom Pid Controller of Active Magnetic Bearings

Nonlinear Model Predictive Control for Doubly Fed Induction Generator with Uncertainties

Two-Degree-of-Freedom Control for Active Magnetic Bearing Flywheel Rotor System Based on Inverse System Decoupling

Vibration Control For Active Magnetic Bearing Rotor System Of High-Speed Flywheel Energy Storage System In A Wide Range Of Speed

Flexible Neural Network-Based Self-Regulation PID of Magnetic Bearing Force Control

Implementation of sliding mode control of giant magnetostrictive smart component by neural network

Research On Modal Analysis And Identification Of The Magnetically Suspended Flywheel

High Stability Control of a Magnetic Suspension Flywheel Based on SA-BPNN and CNN+LSTM+ATTENTION

A Fuzzy Controller Design For Active Magnetic Bearing System

The Influence of PID Controller Parameters on Polarity Switching Control for Unbalance Compensation of Active Magnetic Bearings Rotor Systems

Multi-variable PID Neural Network Decoupling Algorithm in Scrap Copper Smelting Process Control