Abstract:A novel interpolation algorithm for parametric curves is proposed. The algorithm improves the machining efficiency and precision greatly with full consideration of the geometrical characteristic of the machining curves and the kinematical characteristic of the machine tools. Firstly, a look-ahead process, including a pre-interpolation and a speed adjustment, is sought to achieve an optimal machining speed profile for the whole parametric curve. The pre-interpolation stage with a constant feedrate is performed on the parametric curve. Critical zones are selected according to the chord errors and the changing values of the speed. The criterion for selection is that the chord error or the changing value of the speed exceeds the given threshold values. Then, a speed adjustment is applied to the sampling points of the critical zones. Meanwhile, the speed profile between two adjacent critical zones is developed with an acceleration/deceleration strategy to satisfy the dynamical requirements. After that, some relevant information about critical zones is stored into a dynamic memory buffer for the following fine interpolation process. Secondly, the fine interpolation is adaptively fulfilled with the data stored in the dynamic memory buffer based on the lengths of adjacent critical zones. Finally, a non-uniform rational basis spline curve is selected for simulation and experiment to demonstrate the feasibility of the proposing algorithm. The experimental results show that the algorithm can achieve not only smooth and high-speed transitions but also high accuracy with the minimization of chord errors in critical zones.

Research on the Interpolation Processing Based on the Acceleration Control Information

LOOK-AHEAD ALGORITHM FOR VELOCITY CONTROL BASED ON PARAMETERIZED CURVE INTERPOLATOR

Research on a New S-curve Acceleration and Deceleration Control Method

A Look-Ahead and Adaptive Speed Control Algorithm for Parametric Interpolation

Research on Cubic Polynomial Acceleration and Deceleration Control Model for High Speed NC Machining

High speed feed control algorithm with piecewise linear continuous jounce

An Applied CNC Acceleration and Deceleration Control Algorithm Research

A New Linear Interpolation Method with Lookahead for High Speed Machining

New Single Segment Acceleration and Deceleration Control Method Based on Cubic Polynomial Model

Feedrate Compensation in Motion Trajectory Control along Parametric Curves

Trajectory and Velocity Planning Algorithm Based on NUBRS curve

An Adaptive Parametric Interpolator for Trajectory Planning

Speed Control In Path Motion

A New Spatial Arc Interpolation Method Using Quaternion Interpolation Algorithm

Study on NC Instruction Interpretations Algorithm with High-Order Differentiability Based on Moving-Average

New look-ahead algorithm for velocity control in high speed machining

Research on acceleration-deceleration control algorithm based on moving average method

An Optimal Curvature Smoothing Method and the Associated Real-Time Interpolation for the Trajectory Generation of Flying Robots.

NURBS Interpolator with Flexible Acceleration and Deceleration Based on Curvature Properties

Research and Implementation of High-Precision Biaxial Tracking Control System Based on NURBS Interpolator

Smooth trajectory generation based on contour error constraint and parameter correction b-spline