Abstract:The European Union imposed minimum industrial fan efficiency levels in 2013 and then increased them in 2015. In the USA, the Department of Energy (DoE) is also developing regulations aimed at eliminating inefficient industrial fans from the market by 2023. A consequence of this regulatory activity is a need to apply design methods originally developed within the aerospace community to the design of high efficiency industrial fans. In this paper, we present a process used to design, numerically verify and experimentally test a high-pressure single-stage axial fan. The goal was a fan design capable of working over a range of blade angles in combination with a single fixed cambered plate stator. We present the process used when selecting blade airfoil sections and the vortex distribution along the blade span. The selected methodology is based on a coupling between the aerodynamic response of each blade profile and the chosen vortex distribution, creating a direct link between the load distribution and the aerodynamic capability of the blade profile section. This link is used to develop radial distributions of blade twist and chord for the selected blade profiles that result in the required radial work distribution. The design method has been enhanced through intermediate verifications using two different numerical methodologies. The methodologies are based on different approaches, in so doing providing confidence in the verification process. The final blade design has been analyzed using a three-dimensional computational fluid dynamic (CFD) code. Results of the CFD analysis indicate that performance of the final blade design is consistent with the design specifications. The paper concludes with a comparison between predicted and experimentally measured performance. The need is clarified for balance between computational and empirical approaches. When used together the development effort results in a lower cost and higher efficiency design than would have been possible using either approach in isolation.

A New Blade Profile for Bidirectional Flow Properly Applicable to a Two-stage Jet Fan

The Blade Shape Optimization of a Low-Pressure Axial Fan Using the Surrogate-Based Multi-Objective Optimization Method

Optimization Design of Centrifugal Fan Impeller Based on Numerical Simulation.

Aerodynamic Optimization of a Transonic Fan Rotor by Blade Sweeping Using Adaptive Gaussian Process

An Optimization on the Stacking Line of Low-Pressure Axial-Flow Fan Using the Surrogate-Assistant Optimization Method

Adjoint Aerodynamic Optimization of a Transonic Fan Rotor Blade with a Localized Two-Level Mesh Deformation Method

A design method of volute profile of multi-blade centrifugal fan based on DRBF model

A model-based design approach for low-pressure axial fan blades considering the air flow system characteristics #

Experimental Study and Optimization Design of Reversible Axial Fan

Diagnosis and Design Improvement of the Internal Flow Field in an Automotive Cooling Fan Based on Boundary Vorticity Dynamics, Part I: Blade Profile Scaling and Rotation

Design of a Single Stage Variable Pitch Axial Fan

Design and Calculation of Direct and Inverse Proposition of Axial Fan

Reverse Thrust Aerodynamics of Variable Pitch Fans

Numerical investigation of the aerodynamic performance and loss mechanism in a low bypass ratio variable cycle engine fan

The matching characteristics and flow mechanisms of partial-height booster rotor and fan rotor for a high-throughflow fan

The Matching Design of Back Vane for Rotor Blade Adjustable Axial Fan Based on AxSTREAM

Basic Analysis on the Design of an Fan Stage With Axial Supersonic Through-Flow Rotor

Aerodynamic Optimization of a Fan/Booster Stage Blade in an Overall Engine Environment

Analysis of the Flow Capacity of Variable Cycle Split Fans at the Middle Speed

Investigation of varying tip clearance gap and operating conditions on the fulfilment of low-speed axial flow fan

An Aerodynamic Analysis of a Robustly Redesigned Modern Aero-Engine Fan