Abstract:The internal flow evolution of the pump was induced with impeller movement. In various conditions, the peak load on centrifugal blade under the change of rotational speed or flow rate was also changed. It would cause an error when inertia load with a safety coefficient (that was difficult to ascertain) was applied in structure design. In order to accurately analyze the impeller stress under various conditions and improve the reliability of pump, based on a mixed flow pump model, the stress distribution characteristic was analyzed under different flow rates and rotational speeds. Based on a three-dimensional calculation model including impeller, guide blade, inlet and outlet, the three-dimension incompressible turbulence flow in the centrifugal pump was simulated by using the standard k-epsilon turbulence model. Based on the sequentially coupled simulation approach, a three-dimensional finite element model of impeller was established, and the fluid-structure interaction method of the blade load transfer was discussed. The blades pressure from flow simulation, together with inertia force acting on the blade, was used as the blade loading on solid surface. The Finite Element Method (FEM) was used to calculate the stress distribution of the blade respectively under inertia load, or fluid load, or combined load. The results showed that the blade stress changed with flow rate and rotational speed. In all cases, the maximum stress on the blade appeared on the pressure side near the hub, and the maximum static stress increased with the decreasing of the flow rate and the increasing of rotational speed. There was a big difference on the static stress when inertia load, fluid load and combined loads was applied respectively. In order to more accurately calculate the stress distribution, the structure analysis should be conducted due to combined loads. The results could provide basis for the stress analysis and structure optimization of pump.

Computation on Turbulent Dilute Liquid-Particale Flows Through a Centrifugal Impeller

Computational Fluid Dynamics Simulation of Hydrodynamics in an Uncovered Unbaffled Tank Agitated by Pitched Blade Turbines

Liquid-gas two-phase flow analysis through a centrifugal pump impeller

Numerical Simulation of Flow in Centrifugal Pump with Complex Impeller

Numerical simulation of gas-liquid two-phase turbulent flows through a centrifugal impeller

Study on flows through centrifugal pump impeller by turbulent simulation

Numerical simulation of three-dimensional turbulent flow in a centrifugal pump impeller

Three-dimensional calculation of oil-bubble flows through a centrifugal pump impeller

Numerical Simulation of Inner Flow Field in Centrifugal Impeller with Long, Middle and Short Blades

Computation of Stress Distribution in a Mixed Flow Pump Based on Fluid-Structure Interaction Analysis

Three-dimensional turbulent flow in a centrifugal pump impeller under design and off-design operating conditions

CFD Simulation of the Mixing and Dispersing of Floating Particles in a Viscous System

Numerical Simulation of Fine Particle Solid-Liquid Two-Phase Flow in a Centrifugal Pump

Simulation of Dense Solid-Liquid Two-Phase Flow in a Pump Impeller

Three-dimensional particle-liquid two phase turbulent flow calculation through a hydraulic turbine runner

Numerical Simulation of 3-D Steady Turbulent Flow in a Double Channel Impeller

Numerical Analysis of a Three-dimensional Turbulent Flow Field in a Centrifugal Impeller

Computation of Unsteady Flow Fields in a Pump Using Sliding Mesh Method

THREE-DIMENSIONAL CALCULATION OF PARTICLE-LIQUID TWO-PHASE TURBULENT FLOW IN A HYDRAULIC TURBINE RUNNER

Computation of Flow Past an In-Line Oscillating Circular Cylinder and a Stationary Cylinder in Tandem Using a CIP-Based Model

Large Eddy Simulation of Silt-Liquid Two-Phase Flow Through a Centrifugal Pump Impeller