Abstract:The efficiency of organic photovoltaic (OPV) cells is rapidly increasing. However, many of the highest performance OPV devices are also the most unstable, including the two widely used benzodithiophene‐co‐thieno[3,4‐b]thiophene polymers, PTB7 and PTB7‐Th. Here it is shown that both the choice of pendant side chain, and solvents used for film deposition, have an important effect on active layer stability. Specifically, polymers with alkylthienyl side chains are found to be less stable than polymers with alkoxy side chains. Secondly, high boiling point solvent additives such as 1,8‐diiodooctane are found to dramatically accelerate photooxidation unless they are removed fully during device processing, which may be attributed to increased oxygen diffusion in films containing residual solvent. Replacing these higher boiling point solvent additives with lower boiling additives can greatly enhance the polymer stability without requiring high vacuum treatment, making these systems more scalable and compatible with roll‐to‐roll printing. Based on this finding, the non‐halogenated solvent system o‐xylene with 2% N‐methylpyrrolidone is explored as a route to achieving higher active layer stability, while maintaining the favorable, intermixed morphology achieved with higher boiling point, halogenated solvent additives. This result offers a promising way forward in the development of scalable, stable, and high‐efficiency organic solar cells. The photooxidative stability of organic photovoltaics using benzodithiophene‐co‐thienothiophene polymers is explored. Both the chemical structure and active layer processing are shown to affect the rate of polymer degradation. Lower boiling point additives deliver higher stability relative to high boiling additives such as 1,8‐diiodooctane, and can contribute to the design of organic solar cells that are both high efficiency and stable.

Solution Stability of Active Materials for Organic Photovoltaics

Toward High Efficiency Organic Photovoltaic Devices With Enhanced Thermal Stability Utilizing P3ht-B-P3pht Block Copolymer Additives

Improving the Thermal Stability of Organic Solar Cells via Crystallinity Control

Promoting the Stability of Organic Photovoltaics by Planar Heterojunction optimization

Optimization of Bulk Heterojunction Organic Photovoltaics

Stability assessment of PTB7‐Th and a quinoxaline‐based polymer in both organic thin film transistors and in organic photovoltaic devices

Photodegradation of small-molecule organic photovoltaics

Realizing the efficiency-stability balance for all-polymer photovoltaic blends

Organic Photovoltaic Stability: Understanding the Role of Engineering Exciton and Charge Carrier Dynamics from Recent Progress

Organic Solar Modules with Good Stability Under Ultraviolet Irradiation

Impact of P3HT Materials Properties and Layer Architecture on OPV Device Stability

Dramatic improvement in the stability and mechanism of high-performance inverted polymer solar cells featuring a solution-processed buffer layer

Thermally Stable Perovskite Solar Cells by Systematic Molecular Design of the Hole-Transport Layer

Low Boiling Point Solvent Additives for Improved Photooxidative Stability in Organic Photovoltaics

Stability Issue of Perovskite Solar Cells under Real‐World Operating Conditions

Enhancing Efficiency and Stability in Organic Photovoltaics through Advanced Material Design and Synthesis Strategies

Study on Stability of Poly(3-Hexylthiophene)/titanium Dioxide Composites As a Visible Light Photocatalyst

Dynamics of the sub-ambient gelation and shearing of solutions of P3HT incorporated with a non-fullerene acceptor o-IDTBR towards active layer formation in bulk heterojunction organic solar cells

Stability of organic solar cells: toward commercial applications

Donor-Acceptor Interface Stabilizer Based on Fullerene Derivatives toward Efficient and Thermal Stable Organic Photovoltaics

A ternary organic electron transport layer for efficient and photostable perovskite solar cells under full spectrum illumination