Abstract:The purpose of the secondary optical design for light emitting diodes (LED) illumination is to rearrange the direct output of LED and then achieve the desired illumination. Usually a lens is applied to realize this function in an LED illumination system, and a freeform lens can do better than the traditional spherical ones. The method in this paper can be used to design a freeform lens in short time, just less than 10 seconds. And this freeform lens is constructed using the numerical solutions of a set of first-order partial differential equations, which are deduced from the Snell's law according to the conservation of energy. Using an LED as the source while immersing it in the lens, a uniform rectangle can be gotten through single refraction, and with uniformity near to 90%. The rectangular illumination also has a relatively clear cut-off line with little blur at the edge. This method can shorten the designing time and improve the performance of LED illumination system. Furthermore, not only rectangle, but other illumination figures can be achieved by freeform lens designed by this method, which can broaden the scope of freeform lens's usage.

Design of A Freeform Reflector for Led Sources Based on A Feedback Method

The design of the freeform reflector for uniform illumination

The Freeform Reflector for Uniform Rectangular Illumination

Freeform Led Lens For Uniform Illumination

Freeform Surface Lens for LED Uniform Illumination.

Freeform Lens Design for LED Illmination

A freeform reflector for a light-emitting diode bicycle head lamp

Combined Feedback Method for Designing A Free-Form Optical System with Complicated Illumination Patterns for an Extended Led Source

Design Of Freeform Lenses For Illuminating Hard-To-Reach Areas Through A Light-Guiding System

Optimized Design of LED Freeform Lens for Uniform Circular Illumination

Secondary Optical Design for LED Illumination Using Freeform Lens

Freeform Surface Lens Design for Uniform Illumination

Using Numerical Solutions of Differential Equations to Form Free Reflector

Design of Compact and Smooth Free-Form Optical System with Uniform Illuminance for LED Source.

53.2: An Optimization Design Method of LED Freeform Lens for Uniform Circular Illumination

Research on Software for Freeform Reflector Design Based on LED

Design method of a light emitting diode front fog lamp based on a freeform reflector

A High-Efficiency Freeform Reflector for a Light-Emitting Diode Low-Beam Headlamp

Feedback Modification Strategy for Designing a Free-Form Optical Surface with Given Illumination Pattern

Ray Targeting for Optimizing Smooth Freeform Surfaces for Led Non-Rotational Illumination

Energy Feedback Freeform Lenses for Uniform Illumination of Extended Light Source LEDs.