Abstract:Purpose - The purpose of this paper is to present an optimal posture evaluation model to control the assembly gaps in aircraft wing assembly. The gaps between two mating surfaces should be strictly controlled in precision manufacturing. Oversizing of gaps will decrease the dimensional accuracy and may reduce the fatigue life of a mechanical product. To reduce the gaps and keep them within tolerance, the relative posture (orientation and position) of two components should be optimized in the assembly process. Design/methodology/approach - Based on the step alignment strategy, i.e. preliminary alignment and refined alignment, the concept of a small posture transformation (SPT) is introduced. In the preliminary alignment, an initial posture is estimated by a set of auxiliary locating points, with which the components can be quickly aligned near each other. In the refined alignment, the assembly gaps are calculated and the formulation of the gaps with component posture is derived by the SPT. A comprehensive weighted minimization model with gap tolerance constraints is established for redistributing the gaps in multi-regions. Powell-Hestenes-Rockafellar optimization, Singular Value Decomposition and K-Dimensional tree searching are introduced for the solution of the optimal posture for localization. Findings - Using the SPT, the trigonometric posture transformation is linearized, which benefits the iterative solution process. Through the constrained model, overall gaps are minimized and excess gaps are controlled within tolerance. Practical implications - This method has been tested with simulated model data and real product data, the results of which have shown efficient coordination of mating components. Originality/value - This paper proposed an optimal posture evaluation method for minimizing the gaps between mating surfaces through component adjustments. This will promote the assembly automation and variation control in aircraft wing assembly.

Optimization of the Motion Control Mechanism of the Hatch Door of Airliner

Bi-Level Design Optimization of the Hatch Door Mechanism

An Assembly Gap Control Method Based on Posture Alignment of Wing Panels in Aircraft Assembly

Optimized Position and Orientation Evaluation of Wing Based on Tolerance Constraints in Aircraft Assembly

Design optimization of multi-objective proportional–integral–derivative controllers for enhanced handling quality of a twin-engine, propeller-driven airplane

Topology Optimization Procedure of Aircraft Mechanical Components Based on Computer-Aided Design, Multibody Dynamics, and Finite Element Analysis

An Optimization on Single-crank-double-rocker Flapping Wing Mechanism

Optimal Design of Dynamic and Control Performance for Planar Manipulator

Investigation of the Controller Parameter Optimisation for A Servomechanism

Structural Optimization of Actuator Distribution in the Sliding Wing

Multi-objective Optimization of Flexure Hinge Mechanism Considering Thermal–mechanical Coupling Deformation and Natural Frequency

Simulation and Optimization Research of the Actuator for Soft-Close Automatic Car Doors

Deviation Modeling and Tolerance Optimization of Remaining Stroke of the Actuator on a Landing Gear

Integrated Design of Aerodynamics, Structures, Propulsion, and Control Based on the Multidisciplinary Optimization Method

Method for Optimizing Manipulator’s Geometrical Parameters and Selecting Reducers

Sensitivity Analysis and Reliability Optimization Method Based on Aircraft Cabin Door Lock Mechanism

Efficient Global Optimization of Advanced Drop-Hinged Flap

Dynamic Simulation and Optismization of the Air Mix Door Control Mechanism in Automotive Air Conditioner

A new method for optimizing the topology of hinge‐free and fully decoupled compliant mechanisms with multiple inputs and multiple outputs

Integrated Optimization of Structure and Control in Ultra-Precision Motion Systems

The Mechanism Optimization Design of Multifunctional Mobile Electric Bed-Chair