Abstract:An elasto-plastic contact modeling approach is proposed to characterize the total contact load and real contact area of rough surface.The finite element method (FEM) is firstly used to analyze the elasto-plastic contact behaviors of asperity against the rigid flat.The effects of four different plastic yielding equations on the load and real area of asperity contact are analyzed.The relations between the dimensionless contact load and the dimensionless deformation calculated with four different plastic yielding equations are the same,and the solutions vary between the Hertz solution and the AF model.Based on the contact stress distributions of different contact loads,the asperity contact regime is divided into the elastic regime,the mixed elasto-plastic regime and the fully plastic regime.The increasing change of contact stress distribution is considered when obtaining the relation between the contact load and the contact deformation.Statistical analysis of the GW (Greenwood J A and Williamson J B P) model is then applied to integrate the formulations of contact load over the rough surface.The model is compared with the purely elastic model,the CEB model,the ZMC model,the KE model and the JG model,and the effect of plasticity index on the relation between the contact load and the mean contact separation of rough surface is also investigated.The results show that the proposed model can better describe the relation between contact load and deformation.The total contact load of rough surface predicted by the proposed method agrees well with the KE model and the ZMC model.With the increase of mean contact separation,the total contact load becomes smaller.The plasticity index has a great effect on the contact load predicted by different models.The difference between the total contact load of rough surface calculated by 6 elasto-plastic models is small at a lower plasticity index,while the difference is greater at a higher plasticity index,especially for the CEB model;and the CEB model predicts the largest contact load of rough surface.

Study on Surface Asperity Flattening in Cold Quasi-Static Uniaxial Planar Compression by Crystal Plasticity Finite Element Method

Finite Element Simulation of Surface Deformation of Polycrystal with a Rough Surface under Repeated Load

Surface Roughness Evolution under Constant Amplitude Fatigue Loading Using Crystal Plasticity

Investigation on Plastic Flow Behaviors of FCC Polycrystalline Aluminum under Pre-Cyclic Tension-Compression Loading: Experiments and Crystal Plasticity Modeling.

Experimental and Finite Element Analysis on an Elastic–Plastic Hemispherical Asperity Contact Against a Rigid Flat in Plane Strain with Bilinear Hardening

Interaction Between Neighboring Asperities During Flattening : A Discrete Dislocation Plasticity Analysis

A Frictionless Normal Contact Model for Flattening Elastoplastic Single Asperity Considering Yield Plateau and Strain Hardening

Crystallographic Study of Surface Finish in Pack Rolling of Thin Sheets

Crystal Anisotropy of AZ31 Magnesium Alloy under Uniaxial Tension and Compression

Dry Frictional Contact of Metal Asperities: A Dislocation Dynamics Analysis

Experimental and Finite Element Analysis of Plastic Domain Evolution of Rough Surfaces during Contact

On plastic anisotropy of constitutive model for rate-dependent single crystal

Inelastic Contact Behaviors of Nanosized Single-Asperity and Multi-Asperity on Α-Fe Surface: Molecular Dynamic Simulations

Fatigue Damage of an Asperity in Frictionless Normal Contact with a Rigid Flat

Micro-Asperity Contact Area Considering Strain Hardening for Metallic Materials

Contact Analysis Between Rough Surfaces Considering the Size-Affected Deformation Behaviour of Multi-Scale Asperities

The Strain Hardening of Micro-Sized Face-Centered-cubic Single Crystal Metals: A Crystal Plasticity Study

Effect of Plastic Flattening on the Shearing Response of Metal Asperities: A Dislocation Dynamics Analysis

Effect of Plasticity and Coalescing for Neighboring Asperities in Contact with a Rigid Flat

Modeling for Normal Contact of Rough Surface Based on Stress Distribution of Asperity Contact

Experimental and Finite Element Analysis of Plastic Domain Evolution of Wavy Surfaces During Contact