Abstract:To achieve high water flux, the majority of positively charged NF membranes consist of a thin active skin deposited on a thick, permeable support, while the connection force between the active layer and the support is a physical force which may cause the membrane unstable in the long running. In general, chemical bond connection may show superior stability. Based on this consideration, a series of positively charged nanofiltration (NF) membranes were prepared by UV-initiated graft polymerization of methacrylatoethyl trimethyl ammonium chloride (DMC) onto polysulfone ultrafiltration membranes in this work. The salts rejection order of these membranes is MgCl2>NaCl>MgSO4≥Na2SO4. Fourier transform infrared spectroscopy in attenuated total reflection mode (FTIR-ATR), atomic force microscopy (AFM), X-ray photoelectron spectroscopy (XPS) and water contact angle were employed to characterize the resulting membranes. The results indicated that the grafting degree (DG) increased with increasing the monomer concentration, prolonging the irradiation time and reducing the irradiation distance. However, the filtration performance was not well correlated with the increasing DG. The NF membrane prepared by photografting in a 1.5M DMC solution for 5min demonstrated high MgCl2 rejection (94.8%) accompanied with high flux (20.3L/m2h) at 0.2MPa. When operation pressure increased to 0.8MPa, the solution flux increased to 60L/m2h, while MgCl2 rejection nearly maintained stable about 92.4%. An interesting phenomenon was also observed in this experiment that the flux of pure water was less than that of salt solution for some NF membranes.

Preparation, Characterization and Solvent Resistance of Γ-Al2o3/α-al2o3 Inorganic Hollow Fiber Nanofiltration Membrane

Characterization of a positively charged composite nanofiltration hollow fiber membrane prepared by a simplified process

Preparation and Characterization of Low-Pressure Nanofiltration Membranes and the Application in the Separation Process of Dye Molecules

High flux positively charged nanofiltration membranes prepared by UV-initiated graft polymerization of methacrylatoethyl trimethyl ammonium chloride (DMC) onto polysulfone membranes

Preparation and Characterization of a Composite Nanofiltration Membrane from Cyclen and Trimesoyl Chloride Prepared by Interfacial Polymerization

Study on Compositions in Aqueous Phase of Hollow Fiber Composite Nanofiltration Membrane

A Novel Composite Nanofiltration Membrane Prepared by Interfacial Polymerization of 2,2′-Bis(1-hydroxyl-1-trifluoromethyl-2,2,2-trifluoroethyl)-4,4′-methylenedianiline and Trimesoyl Chloride

Preparation of Al2O3 - SiO2 Composite Membranes Supported on Al2O3 Hollow Fiber

Effect of nano-sized Al2O3-particle addition on PVDF ultrafiltration membrane performance

Preparation of high permeance thin-film composite nanofiltration membrane on macroporous ceramic support

Ultrathin Alginate Coatings As Selective Layers for Nanofiltration Membranes with High Performance.

Novel High-Flux Polyamide/tio2 Composite Nanofiltration Membranes on Ceramic Hollow Fibre Substrates

Preparation of high performance nanofiltration membrane by different dihydric alcohol in aqueous phase

Gel Composite Membrane with Tannic Acid/Ferric Ion Separation Layer for Organic Solvent Nanofiltration

Preparation of Al2O3/ZrO2 composite membranes supported by hollow fibers made from inorganic salt precursors

Stability of Nano-Al_2O_3 Sol and Properties of PVDF/Al_2O_3 Hybrid Membrane

One-Step Fabrication of High Selective Hollow Fiber Nanofiltration Membrane Module

Preparation, characterization and permeation property of Al2O3, Al2O3–SiO2 and Al2O3–kaolin hollow fiber membranes

Hollow fibers for nanofiltration/organic solvent nanofiltration

A High Performance Silica–fluoropolyamide Nanofiltration Membrane Prepared by Interfacial Polymerization

Study on the preparation of gradient-dense Al2O3 hollow fiber membranes by co-sintering process