A Chlorine-Tolerant Nanofiltration Membrane Prepared by the Mixed Diamine Monomers of Pip and Bhttm

Yong-Jian Tang,Zhen-Liang Xu,Shuang-Mei Xue,Yong-Min Wei,Hu Yang
DOI: https://doi.org/10.1016/j.memsci.2015.10.028
IF: 9.5
2016-01-01
Journal of Membrane Science
Abstract:Using Polysulfone (PSF) ultrafiltration (UF) membrane as porous support, a chlorine-tolerant nanofiltration (NF) membrane was prepared by interfacial polymerization of piperazine (PIP) and 2,2'-bis(1-hydroxyl-1-trifluoromethyl-2,2,2-triflutoethyl)-4,4'-methylenedianiline (BHTTM) mixture with trimesoyl chloride (TMC). The XPS, SEM, AFM and contact angle methods were employed to characterize the physicochemical properties and morphology of the prepared NF membranes. The effects of preparation conditions such as reaction time, monomers mixing ratio and oxidation treatment on NF membrane performance were investigated. The salt rejection of the NF membrane met the order of Na2SO4>MgSO4>NaCl, indicating the membrane possessed a negative surface charge. The results showed the NF membrane prepared under the optimum conditions exhibited pure water flux (PWF) with 79.1 (L/m2h) and Na2SO4 rejection of 99.5% under 0.6MPa. The optimized post oxidation condition was treated by 3000ppm NaClO solution for 1h. The best NF membrane had a molecular weight cut-off (MWCO) less than 300Da, corresponding to the pore size of 1nm, which was calculated from the rejection of carbohydrates. The robustness of the NF membrane was proven by showing satisfactory stability in the long time running.
What problem does this paper attempt to address?