Abstract:Reverse electrodialysis heat engine (REDHE) emerges great potential to harvest the low-grade heat (LGH) produced during the industrial processes and renewable energy utilizations. In the closed-loop system, the power generation unit converts the salinity gradient power (SGP) to electric energy using the reverse electrodialysis (RED) cells, and the regeneration unit recovers the salinity gradient based on LGH. As two units are in series, the regeneration and power generation units should be collaboratively optimized to achieve a high performance of REDHE. Herein, a framework which can unitedly simulate the both units is built, which enables to divide the total efficiency of REDHE to the respective efficiencies of units. LiBr solution as the working fluid and the effects of initial salt concentration, concentration of the high concentration (HC) solution and temperature in RED cells are considered. Results show that the total efficiencies increase with the concentration of HC solution and the RED temperature due to the production of more chemical energy in the regeneration unit. However, a non-monotonic trend of the total efficiency with the initial concentration is discovered, which increases from 4.91% to 5.42% and then decreases to 4.69% when the initial concentration raises from 20 wt% to 25 wt% and then reaches 30 wt% at RED temperature of 25 °C. Although enhancing the RED temperature to 50 °C leads the total efficiencies increase to 6.25%, 7.13% and 6.38%, respectively, the trend is unchanged. The respective efficiencies of units explain the phenomenon by that a higher salinity can decrease the efficiency of the power generation unit by reducing the ionic selectivity in the RED cells, but enhance the efficiency of the regeneration unit. Therefore, the highest total efficiency reached at initial concentration of 25 wt% is the trade-off between the efficiencies of two units. This study indicates that increasing the concentration of HC solution, the RED temperature, and carefully selecting a compromise initial concentration are helpful to achieve a high energy efficiency in a REDHE.

Reducing pumping energy by using different flow rates of high and low concentration solutions in reverse electrodialysis cells

Performance Analysis of Reverse Electrodialysis Stacks: Channel Geometry and Flow Rate Optimization

Collaborative optimization of regeneration unit and power generation unit in reverse electrodialysis heat engine for low-grade heat recovery

Influence of Solution Concentration and Salt Types on the Performance of Reverse Electrodialysis Cells

Investigating the effect of temperature and concentration on the performance of reverse electrodialysis systems

The Influence of Different Factors on the Power-Generation Performance of Reverse Electrodialysis

Water trapping inside anion exchange membranes during practical reverse electrodialysis applications

Revised spacer design to improve hydrodynamics and anti-fouling behavior in reverse electrodialysis processes

Investigation on energy conversion efficiency of series RED stacks power generation system in solution co-flow or counter-flow

Multi-stage Reverse Electrodialysis: Strategies to Harvest Salinity Gradient Energy

Effect of current-induced ion transfer on the electrical resistance of reverse electrodialysis stack by chronopotentiometry

Tracing the impact of stack configuration on interface resistances in reverse electrodialysis by in situ electrochemical impedance spectroscopy

Enhanced Ionic Conductivity and Power Generation Using Ion-Exchange Resin Beads in a Reverse-Electrodialysis Stack

Reverse Electrodialysis Characteristic of the LiBr-ethanol-water Ternary Solution

Reverse Electrodialysis In Bilayer Nanochannels: Salinity Gradient-Driven Power Generation

Performance improvement of LiBr-H2O reverse electrodialysis unit for heat to power conversion with finite solution flowrate and large concentration change

Mitigating the influence of multivalent ions on power density performance in a single-membrane capacitive reverse electrodialysis cell

The Effect of Flow Modes on the Capture of the Energy Between Concentrated Brine and Seawater by Reverse Electrodialysis

Temperature Regulated Reverse Electrodialysis in Charged Nanopores

Experimental Study on the Effects of Salt Solution Ph on the Performance of Reverse Electrodialysis Stack

Reverse Electrodialysis for Power Production with Ion-Permselective Spacers and Its Optimization