Polyamide Interfacial Composite Membranes Prepared from M-Phenylene Diamine, Trimesoyl Chloride and a New Disulfonated Diamine

Wei Xie,Geoffrey M. Geise,Benny D. Freeman,Hae-Seung Lee,Gwangsu Byun,James E. McGrath
DOI: https://doi.org/10.1016/j.memsci.2012.02.038
IF: 9.5
2012-01-01
Journal of Membrane Science
Abstract:The influence of synthesis conditions (e.g., monomer concentration and membrane preparation protocol) on transport properties of polyamide thin-film composite (TFC) membranes prepared using m-phenylenediamine (MPD) and trimesoyl chloride (TMC) via interfacial polymerization is reported. For example, at 25°C, NaCl rejection and permeate flux combinations of 99.6±0.1% and 42±3L/(m2h), respectively, were achieved in crossflow filtration using a 2000ppm aqueous solution of NaCl and a transmembrane pressure difference of 225psi (15.5bar). Additionally, a sulfone diamine, disulfonated bis[4-(3-aminophenoxy)phenyl]sulfone (S-BAPS), was used in place of MPD to prepare TFC membranes. The resulting membranes had low NaCl rejection but somewhat higher permeate flux than MPD/TMC membranes. These membranes had reduced chlorine tolerance compared to those prepared using MPD as the diamine.
What problem does this paper attempt to address?