Selective Hydrogenolysis Of Erythritol Over Ir-Reox/Rutile-Tio2 Catalyst
Minyan Gu,Lujie Liu,Yoshinao Nakagawa,Congcong Li,Masazumi Tamura,Zheng Shen,Xuefei Zhou,Yalei Zhang,Keiichi Tomishige
DOI: https://doi.org/10.1002/cssc.202002357
IF: 8.4
2021-01-01
ChemSusChem
Abstract:Partial hydrogenolysis of erythritol, which can be produced at large scale by fermentation, to 1,4-butanediol (1,4-BuD) is investigated with Ir-ReOx/SiO2 and Ir-ReOx/rutile-TiO2 catalysts. In addition to the higher conversion rate over Ir-ReOx/TiO2 than over Ir-ReOx/SiO2, which has been also reported for glycerol hydrogenolysis, Ir-ReOx/TiO2 showed higher selectivity to 1,4-BuD than Ir-ReOx/SiO2, especially at low conversion levels, leading to high 1,4-BuD productivity of 20 mmol(1,4-BuD) g(Ir)(-1) h(-1) at 373 K (36 % conversion, 33 % selectivity). The productivity based on the noble metal amount is higher than those reported previously, although the maximum yield of 1,4-BuD (23 %) is not higher than the highest reported values. The reactions of various triols, diols and mono-ols are tested and the selectivity and the reaction rates are compared between catalysts and between substrates. The Ir-ReOx/TiO2 catalyst showed about twofold higher activity than Ir-ReOx/SiO2 in hydrogenolysis of the C-OH bond at the 2- or 3-positions in 1,2- and 1,3-diols, respectively, whereas the hydrogenolysis of C-OH at the 1-position is less promoted by the TiO2 support. Lowering the loading amount of Ir on TiO2 (from 4 wt % to 2 or 1 wt %) decreases the Ir-based activity and 1,4-BuD selectivity. Similarly, increasing the loading amount on SiO2 from 4 wt % to 20 wt % increases the Ir-based activity and 1,4-BuD selectivity, although they remain lower than those for TiO2-supported catalyst with 4 wt % Ir. High metal loadings on the support seem to be important.