Preparation and Characterization of Low Methoxyl Pectin by High Hydrostatic Pressure-Assisted Enzymatic Treatment Compared with Enzymatic Method under Atmospheric Pressure

Wenting Zhao,Xingfeng Guo,Xueli Pang,Lin Gao,Xiaojun Liao,Jihong Wu
DOI: https://doi.org/10.1016/j.foodhyd.2015.04.004
IF: 10.7
2015-01-01
Food Hydrocolloids
Abstract:A commercial pectin was de-esterified by using the HHP-assisted enzymatic method (E-HHP), and the effects of pressure, temperature and pressure-holding time on the degree of esterification (DE) of pectin de-esterified by E-HHP were investigated. A single factor experiment and an orthogonal test were performed to optimize the de-esterification condition of E-HHP. The optimal conditions of E-HHP consisted of a pressure of 400 MPa, a temperature of 45 degrees C and a pressure-holding time of 15 min. Under the optimal conditions, the DE was decreased from 65.32 +/- 0.64% to 28.08 +/- 1.39% within 15 min, whereas 120 min was required to obtain pectin with a similar DE (26.64 +/- 1.00%) using the enzymatic method under atmospheric pressure (E-AP). The physicochemical properties, rheological and gelling characteristics of pectin de-esterified by E-HHP and E-AP were also compared. The results showed that the pectin prepared by E-HHP had much higher viscosity and induced a rapid and homogeneous gelation, leading to the formation of gel with better viscoelastic properties, whereas the other characteristics showed no significant difference. E-HHP had no degradation action on the pectin molecule as demonstrated by the viscosity-average molecular weight and molecular weight distribution. From these results, it could be concluded that E-HHP is a highly efficient and novel method to prepare low methoxyl pectin. (C) 2015 Elsevier Ltd. All rights reserved.
What problem does this paper attempt to address?