Noncrossover Dither Creeping Mutation-Based Genetic Algorithm for Pipe Network Optimization

Feifei Zheng,Aaron C. Zecchin,Angus R. Simpson,Martin F. Lambert
DOI: https://doi.org/10.1061/(asce)wr.1943-5452.0000351
IF: 3.457
2014-01-01
Journal of Water Resources Planning and Management
Abstract:A noncrossover dither creeping mutation-based genetic algorithm (CMBGA) for pipe network optimization has been developed and is analyzed in this paper. This CMBGA differs from the classic genetic algorithm (GA) optimization in that it does not utilize the crossover operator; instead, it only uses selection and a proposed dither creeping mutation operator. The creeping mutation rate in the proposed dither creeping mutation operator is randomly generated in a range throughout a GA run, rather than being set to a fixed value. In addition, the dither mutation rate is applied at an individual chromosome level rather than at the generation level. The dither creeping mutation probability is set to take values from a small range that is centered about 1/ND (where ND = number of decision variables of the optimization problem being considered). This is motivated by the fact that a mutation probability of approximately 1/ND previously has been demonstrated to be an effective value and is commonly used for the GA. Two case studies are used to investigate the effectiveness of the proposed CMBGA. An objective of this paper is to compare the performance of the proposed CMBGA with four other GA variants and other published results. The results show that the proposed CMBGA exhibits considerable improvement over the considered GA variants, and comparable performance with respect to other previously published results. Two big advantages of the CMBGA are its simplicity and the fact that it requires the tuning of fewer parameters compared with other GA variants.
What problem does this paper attempt to address?