Abstract:The COM-Poisson distribution generalizes the standard Poisson distribution, allowing for under- or over-dispersion. It is used to model defect counts in manufacturing processes with over- or under-dispersed non-conforming products. The COM-Poisson distribution has two parameters; the rate parameter (@m) and dispersion parameter (@n). This study proposes three kinds of cumulative sum (CUSUM) control charts based on either the rate parameter, dispersion parameter, or both to detect shifts. Two control charts, namely, @m-CUSUM and @n-CUSUM detect shift respectively on one of two parameters, while a single CUSUM chart, namely, s-CUSUM considers the shift in both parameters at once. The proposed @m-CUSUM chart is flexible for over- or under-dispersed data and generalizes the Bernoulli, the Poisson and the geometric CUSUM charts as its special cases. The performance of the proposed charts have been evaluated in terms of average number of signals (ANOS) and compared with the Sellers (2012) chart. The performance comparison shows that the flexible and generalized @m-CUSUM chart is better to detect small to moderate shifts in the Poisson parameter than the Sellers (2012) chart. The @n-CUSUM performs very well to detect small to moderate shifts in the dispersion parameter. The performance evaluations of the s-CUSUM chart showed that, it works better when both of the parameter increases (decreases), but very poorly if one parameter increases (decreases) and other parameter decreases (increases). Two numerical examples are given to demonstrate the application of the proposed charts on practical data sets.

A Markov Chain Model for the Adaptive Cusum Control Chart

Cumulative sum charts for monitoring the COM-Poisson processes

A likelihood-based adaptive CUSUM for monitoring linear drift of Poisson rate with time-varying sample sizes

In-control Robustness Comparison of Different Control Charts.

Run Length Analysis for Multivariate Cumulative Sum Control Chart Based on Markov Chains

Adaptive EWMA and CUSUM charts with dynamic probability control limits

An Engineering-Effective Adaptive Model Algorithm Control (AMAC) and Simulation

Nonparametric Adaptive CUSUM Chart for Detecting Arbitrary Distributional Changes

Cusum and Ewma Multi-Charts for Detecting A Range of Mean Shifts

Parametric and nonparametric versions of adaptive CUSUM charts for monitoring the location of individual measurements

The Impact of Varying Patient Populations on the In-Control Performance of the Risk-Adjusted Cusum Chart

A New Cumulative Sum Quality Control Scheme for Monitoring the Process Mean

Nonparametric adaptive cumulative sum charting scheme for monitoring process location

A new control chart based on proportional hazards and frailty regression models for monitoring high‐quality processes with censored observations

Kernel-Based Multivariate Nonparametric CUSUM Multi-Chart for Detection of Abrupt Changes

A weighted dual cumulative sum chart for monitoring the process mean

Two CUSUM schemes for simultaneous monitoring of parameters of a shifted exponential time to events

Adaptive Charting Techniques: Literature Review and Extensions

A Change-Point Based Control Chart for Detecting Sparse Changes in High-Dimensional Heteroscedastic Data

The efficiency of CUSUM schemes for monitoring the multivariate coefficient of variation in short runs process

Efficient Design and Sensitivity Analysis of Control Charts Using Monte Carlo Simulation