Constructing B-Spline Solid With Integrating Representation Of Materials And Mechanical Performance
Chen Long,Wang Meng,Xu Gang,Liu Yusheng
2016-01-01
Abstract:Modeling of products is an important field. Although the conventional product modeling methods are still widely used in product design, they only aim at designing homogeneous products. In recent decades, abundant heterogeneous products emerged and had been used in many fields, such as biomedical and aeronautics and astronautics. The conventional computer-aided design modeling methods have many problems when applied to designing heterogeneous products. For example, many defects such as the separation of geometry, materials and properties, too many manual interactions, no share of model throughout the whole design and analysis stages, make the design and optimization of heterogeneous products more difficult. In recent years, Isogeometric analysis method based on volume parametric model has been proposed and applied in many product design fields. The purpose of this paper is to develop a combined model by integrating on volume parametric model with product geometry, material properties and physical laws. We will discuss the realization of the modeling approach. More clearly, CT scanning data is used as the information source of geometry and material. Geometrical reverse engineering method is adopted to construct a B-spline solid. Material reverse method is taken to acquire the material composition on the control points for the B-spline solid. Different from other heterogeneous product design methods, our method emphasizes the above mentioned reverse engineering methods. Our method has several advantages: Firstly, The Isogeometric analysis method can be implemented and applied without model conversion and precision loss; Secondly, the physical field information on every control point can be easily acquired. Thirdly, the geometric properties, material properties can be queried inside the entire model via the volume parameterization theory. Two examples are presented to show the effectiveness of our modeling method.