Abstract:As emerging and revolutionary alloy materials, high entropy alloys (HEAs) have been extensively studied because of their unique composition, microstructures and excellent mechanical properties and performances. However, there have been limited studies on the deformation behaviors and mechanisms of HEA single crystals at the micro/nanoscale. Here, we fabricated single-crystalline CoCrFeNi HEA pillars with typical orientations of <100>, <110> and <111> and diameters ranging from 272 nm to 1,253 nm and then conducted in situ uniaxial compression tests on these fabricated micro/nanopillars inside a scanning electron microscope. The in situ compression tests showed pronounced size effects on yield and flow stresses in the <100>-, <110>- and <111>-oriented micro/nanopillars, i.e., both yield and flow stresses follow a scaling law with pillar diameter. The scaling exponents of <110>- and <111>-oriented micro/nanopillars are approximately -0.60, which is close to those of face-centered-cubic (FCC) pure metallic micro/nanopillars. However, the <100>-oriented pillars, having a scaling exponent of -0.32∼-0.17, exhibit weaker size effects on yield and flow stresses compared with the <110>- and <111>-oriented micro/nanopillars. Combining observations and analyses using transmission electron microscopy, and large-scale atomistic simulations, we revealed that the nucleation and slip of full dislocations dominate the plastic deformation in the <110>- and <111>-oriented micro/nanopillars, while deformation twinning is a governing mechanism in the <100>-oriented micro/nanopillars. These underlying deformation mechanisms are responsible for the size effects of single-crystalline HEA micro/nanopillars. Large-scale atomistic simulations further reveal that twin nucleation in <100>-oriented pillars is initiated by the slip of pre-existing partial dislocations from an internal source. By considering the free energy change during partial slip, we used a theoretical model to predict the scaling law for the size effects of <100>-oriented micro/nanopillars. The predicted scaling exponent for the size effect of <100>-oriented micro/nanopillars is consistent with our experimental results. Our current study sheds light on the underlying deformation mechanisms in FCC HEA single crystals at the micro/nanoscale, which provides a guide for the design and fabrication of HEAs with high strength and remarkable plasticity.

Effect of Surface Nanocrystals on the Plastic Deformation Behavior in Micro Compression

Numerical Exploration of Plastic Deformation Mechanisms of Copper Nanowires with Surface Defects

Size Effects on the Wave Propagation and Deformation Pattern in Copper Nanobars under Symmetric Longitudinal Impact Loading

An investigation of the combined size and rate effects on the mechanical responses of FCC metals

Anisotropic Deformation in the Compressions of Single Crystalline Copper Nanoparticles

Strain Rate Effect on Plastic Deformation of Nanocrystalline Copper Investigated by Molecular Dynamics

Grain Size Effect on the Plastic Deformation of Nanocrystalline Silver

An Elastic–viscoplastic Model of Deformation in Nanocrystalline Metals Based on Coupled Mechanisms in Grain Boundaries and Grain Interiors

The Influence of Nano/micro Sample Size on the Strain-Rate Sensitivity of Plastic Flow in Tungsten

Size Effects in Strength and Strain Hardening Behavior of Single-Crystal 7075 Aluminum Alloy Micropillars

Molecular Dynamics Simulation of the Deformation of Al Nanopillars

Deformation of Nanoporous Copper Subjected to High-Rate Compression at Various Temperatures

Effect of Aspect Ratio on the Deformation Behavior of Dislocation-Free Ni3Al Nanocubes

In situ TEM study of microplasticity and Bauschinger effect in nanocrystalline metals

A stochastic crystal plasticity model with size-dependent and intermittent strain bursts characteristics at micron scale

Pramatic Atomistic Analysis of Nano-scale Metal Plasticity

Orientation-dependent plastic flow in nanoscratching of copper surfaces

Influence of surface pre-deformation on the Portevin-Le Chatelier effect and the related multiscale complexity of plastic flow in an Al-Mg alloy

Size effects and plastic deformation mechanisms in single-crystalline CoCrFeNi micro/nanopillars

Revealing size effect for plastic deformation of nanocrystalline NiTi SMA at moderate temperature by combining CPFEM with experiment

Effects of Rate, Size and Prior Deformation in Microcrystal Plasticity