Abstract:Delafossite CuAlO2 has great potential in optoelectronics applications. The intrinsic point defects play the decisive roles in the optoelectronic properties and application of CuAlO2. However, there are still disputes about their relevant underlying physical mechanisms at the atomic scale. Here, the formation of intrinsic point defects of CuAlO2 and their effects on optical absorption spectra and electronic structure have been systematically investigated using first‐principles calculations. In oxygen‐rich and oxygen‐poor chemical environments, acceptor‐type defects such as Cu vacancy and Cu substitution on the Al site can spontaneously form and produce p‐type conductivity at room temperature. This is the important physical basis for CuAlO2 to be widely used as transparent conductive oxide films. The shallow acceptor‐type levels produced by Cu substitution on Al site and O vacancy, and the shallow donor‐type levels produced by interstitial Cu, are favorable for the separation of photo‐generated electron‐hole pairs, which can be suitable for applications in photocatalysis and photovoltaics. The Cu or Al vacancy can produce delocalized energy band at the top of valence band and pinning Fermi level at the same time, which may make CuAlO2 a degenerate semiconductor and produce local surface plasmon resonance effect. Al substitution on Cu site and interstitial Al or O form complex deep defect energy bands in the forbidden band and produce significant multiband optical absorption in the visible‐NIR region. They are expected to become alternative materials for photoluminescence and photoelectric detection. This work demonstrates the importance of intrinsic defect engineering for optimizing optoelectronic properties and thus promoting the discovery of novel optoelectronic materials. This article is protected by copyright. All rights reserved

Alumina Photonic Crystals with Defect Modes for Sensor Application

Fabrication of One-Dimensional Alumina Photonic Crystals with a Narrow Band Gap and Their Application to High-Sensitivity Sensors

Annular Photonic Crystal Defect Mode For Operation Of Single-Mode Laser

Defect Mode-Induced Unidirectional Flexural Wave Transmission Using Prismatic Beams with Concentrated Gradient Masses

Tuning the Thermal Conductivity of Silicon Phononic Crystals Via Defect Motifs: Implications for Thermoelectric Devices and Photovoltaics

Study on defect modes in one-dimensional photonic crystals with periodic double defect layers of single-negative-materials

An ultracompact refractive index gas-sensor based on photonic crystal microcavity

High-Q Width Modulated Photonic Crystal Stack Mode-Gap Cavity and Its Application to Refractive Index Sensing.

Direct Observation of Iso-Frequency Contour of Surface Modes in Defective Photonic Crystals in Real Space

New insights into intrinsic point defects of Delafossite CuAlO2 as optoelectronic materials

Modulating electromagnetic properties in three‐dimensional diamond‐structured photonic crystals with double planar defects

Theoretical Investigation of a Sensor Based on One-Dimensional Photonic Crystals to Measure Four Physical Quantities

1D porous silicon photonic crystals comprising Tamm/Fano resonance as high performing optical sensors

Slow light-based refractive index sensor in single mode photonic crystal waveguide

Defect Engineering of Nanocrystal‐In‐Glass Composites for Ultrashort Optical Pulse Monitoring

Tuning Optical Properties of Photonic Crystal of Anodic Alumina and the Influence of Electrodeposition

High Sensitivity Hydrogen Sensor via the Coupling of Tamm Plasmon Polaritons and Defect Mode

Ultra-sensitive pressure sensing capabilities of defective one-dimensional photonic crystal

Two-dimensional valley photonic crystal resonant cavities

Ultra-high sensitive cancerous cells detection and sensing capabilities of photonic biosensor

Point defect states emergence in a plasmonic crystal