Abstract:The anisotropic plasticity of sheet metals at high strain rates is a critical factor that can influence the fabrication and service safety of engineering parts under dynamic loading conditions. The characterization of dynamic anisotropic plasticity using conventional testing methods usually suffers from the limitations resulted from the homogeneous deformation state and one-dimensional wave propagation preconditions. In this work, a highly efficient approach is proposed for the simultaneous identification of the anisotropic yielding and hardening constitutive parameters at high strain rates based on the heterogeneous impact test and the virtual fields method. First, the identification framework that combines the selected anisotropic plasticity constitutive models and the principle of virtual work concerning the dynamic kinematics term is introduced. In order to validate the proposed identification algorithm, simulated virtual impact tests were performed to provide reference parameters and unpolluted inertial acceleration/strain/strain rate field data. These data were then processed to extract the target dynamic anisotropic parameters. The results show that using the double-notched impact configuration and the proposed identification algorithm the selected anisotropic yielding and hardening parameters can be reasonably identified from a single impact test, significantly simplifying the testing procedures compared to conventional dynamic testing methods. Also, the effects of different processing parameters and influential factors on the identification accuracy have been investigated. From the sensitivity studies, the preferred ranges of the processing parameters have been determined and the robustness of the proposed method within these verified.

An Experimental Method to Measure Dynamic Stress-Strain Relationship of Materials at High Strain Rates

A Novel Methodology for Large Strain under Intermediate Strain Rate Loading

On Measuring the Dynamic Elastic Modulus for Metallic Materials Using Stress Wave Loading Techniques

A Method to Predict Structural Dynamic Strain Based on Acceleration Signal

A Method Of Measuring Dynamic Strain Under Electromagnetic Forming Conditions

Design of a Novel High-Speed Tensile Method for Testing the High Strain Rate Tensile Behavior of Aluminum Alloys.

Novel Method for Testing the High Strain Rate Tensile Behavior of Aluminum Alloys

A NEW LOADING TECHNIQUE FOR MEASURING SHEARING PROPERTIES OF MATERIALS UNDER HIGH STRAIN RATES

Characterizing Multi Mechanical Behaviors for Epoxy-Like Materials under Wide Strain Rate Range

Research on Full Strain Measurement Performance of Non-intrinsic Optical Fiber F-P Sensor

Experimental Methodology for Obtaining the Flow Curve of Sheet Materials in a Wide Range of Strains

Ultrasonic Measurement of Stress Considering Strain Effect

Dynamic Testing Technique Based on Multi-channel Photonic Doppler Velocimetry for Investigating the Dynamic Behavior of Materials

On the Development of New Test Techniques to Measure the Tensile Response of Materials at High and Ultra-high Strain Rates

Static and dynamic measurement of low-level strains with carbon fibers

Characterization of Dynamic Tensile Testing Using Aluminum Alloy 6061-T6 at Intermediate Strain Rates

Non-destructive mapping of stress, strain and stiffness of thin elastically deformed materials

A Method of the Residual Stress Dynamic Measurement Research

Non-Contacting Strain Measurement in Dynamic Tensile Testing

Study on the dynamic behavior of tungsten alloy at strain rates up to 5000 s-1

A VFM-based identification method for the dynamic anisotropic plasticity of sheet metals