Modelling of radiative divertor operation towards detachment in experimental advanced superconducting tokamak

yiping chen,f q wang,x j zha,l q hu,h y guo,z w wu,x d zhang,b n wan,j g li
DOI: https://doi.org/10.1063/1.4791659
IF: 2.2
2013-01-01
Physics of Plasmas
Abstract:In order to actively control power load on the divertor target plates and study the effect of radiative divertor on plasma parameters in divertor plasmas and heat fluxes to the targets, dedicated experiments with Ar impurity seeding have been performed on experimental advanced superconducting tokamak in typical L-mode discharge with single null divertor configuration, ohmic heating power of 0.5 MW, and lower hybrid wave heating power of 1.0 MW. Ar is puffed into the divertor plasma at the outer target plate near the separatrix strike point with the puffing rate 1.26 x 10(20) s(-1). The radiative divertor is formed during the Ar puffing. The SOL/divertor plasma in the L-mode discharge with radiative divertor has been modelled by using SOLPS5.2 code package [V. Rozhansky et al., Nucl. Fusion 49, 025007 (2009)]. The modelling shows the cooling of the divertor plasma due to Ar seeding and is compared with the experimental measurement. The changes of peak electron temperature and heat fluxes at the targets with the shot time from the modelling results are similar to the experimental measurement before and during the Ar impurity seeding, but there is a major difference in time scales when Ar affects the plasma in between experiment and modelling. (C) 2013 American Institute of Physics. [http://dx.doi.org/10.1063/1.4791659]
What problem does this paper attempt to address?