Abstract:According to recent DIII-D experiments (N.C. Logan et al 2024 Nucl.Fusion 64 014003), injecting edge localized electron cyclotron current drive (ECCD) in the counter-plasma-current (counter-Ip) direction reduces the n = 3 resonant magnetic perturbation (RMP) current threshold for ELM suppression, while co-Ip ECCD during the suppressed ELM phase causes a back transition to ELMing. This paper presents nonlinear two-fluid simulations on the ECCD manipulation of edge magnetic islands induced by RMP using the TM1 code. In the presence of a magnetic island chain at the pedestal-top, co-Ip ECCD is found to decrease the island width and restore the initially degraded pedestal pressure when its radial deposition location is close to the rational surface of the island. With a sufficiently strong co-Ip ECCD current, the RMP-driven magnetic island can be healed, and the pedestal pressure fully recovers to its initial ELMing state. On the contrary, counter-Ip ECCD is found to increase the island width and further reduce the pedestal pressure to levels significantly below the peeling-ballooning-mode limited height, leading to even stationary ELM suppression. These simulations align with the results from DIII-D experiments. However, when multiple magnetic island chains are present at the pedestal-top, the ECCD current experiences substantial broadening, and its effects on the island width and pedestal pressure become negligible. Further simulations reveal that counter-Ip ECCD enhances RMP penetration by lowering the penetration threshold, with the degree of reduction proportional to the amplitude of ECCD current. For the ~1 MW ECCD in DIII-D, the predicted decrease in the RMP penetration threshold for ELM suppression is approximately 20%, consistent with experimental observations. These simulations indicate that edge-localized ECCD can be used to either facilitate RMP ELM suppression or optimize the confinement degradation.

Stabilizing effects of edge current density on pedestal instabilities

Microturbulence in Diii-D Tokamak Pedestal. I. Electrostatic Instabilities

Stabilizing Effects of Enhanced Resistivity Due to Lithium-Conditioning on Low-N Edge Localized Modes in Nstx

Stabilizing Effect of Enhanced Resistivity on Peeling-Ballooning Instabilities on EAST

Effects of edge-localized electron cyclotron current drive on edge-localized mode suppression by resonant magnetic perturbations in DIII-D

Global Gyrokinetic Simulation of Tokamak Edge Pedestal Instabilities

Edge Localized Linear Ideal Magnetohydrodynamic Instability Studies in an Extended-Magnetohydrodynamic Code

Destabilizing Effects of Edge Infernal Components on Resistive Wall Modes in Advanced Tokamak Scenarios

Stabilizing effects of resistivity on low-n edge localized modes in NSTX

Numerical modeling of pedestal stability and broadband turbulence of wide-pedestal QH-mode plasmas on DIII-D

Enhanced pedestal transport driven by edge collisionality on Alcator C-Mod and its role in regulating H-mode pedestal gradients

Curvature of Radial Electric Field Aggravates Edge Magnetohydrodynamics Mode in Toroidally Confined Plasmas

The formation of an radial edge electric field due to finite ion orbit width effects is the possible root cause of the H-mode edge

Impact of E × B shear flow on low-n MHD instabilities

Excitation of Edge Plasma Instabilities and Their Role in Pedestal Saturation in the Hl-2a Tokamak

Theory of edge localized mode suppression by static resonant magnetic perturbations in the DIII-D tokamak

Impact of the Pedestal Plasma Density on Dynamics of Edge Localized Mode Crashes and Energy Loss Scaling

Linear Calculations of Edge Current Driven Kink Modes with BOUT++ Code

Enhanced Toroidal Flow Stabilization of Edge Localized Modes with Increased Plasma Density

Formation of Edge Pressure Pedestal and Reversed Magnetic Shear Due to Toroidal Rotation in a Tokamak Equilibrium

Stabilizing Effect of Resistivity Towards ELM-free H-mode Discharge in Lithium-Conditioned NSTX