Abstract:Potential flow based vortex numerical methods have been widely used in aerodynamics and hydrodynamics. In these methods, vortices shed from lifting bodies are traced by using vortex filaments or dipole panels. When the wake elements encounter a downstream body, such as a rudder behind a propeller or a stator behind a rotor, a treatment is necessary to divert the wake elements to pass by the body. This treatment is vital to make wake simulations realistic and to satisfy the non-penetration condition during wake body interaction. It also helps to avoid pure numerical disturbances such as when a vortex filament or an edge of a dipole panel passes through the collection point of a body element; this is a singularity for induced velocity and it will introduce a large numerical disturbance. This necessary treatment for three-dimensional problems with geometrical complexity has not been found to date. In this study, a wake impingement model was developed to divert wake elements to slip over the body surface, model the vortex/body interaction, and predict forces on fluctuating components. The model was also tested on configurations of oscillating foils in tandem with an existing panel method code. Simulation results with the wake impingement model are shown to be in closer agreement with limited published experimental data than those without the model. With the established wake impingement model, force fluctuations on the after body due to the wake vortex impingement were investigated based on a series of simulations. The series varied several parameters including distance between two foils, oscillating frequency, span, rear foil pitch angle, swap angle and vertical position.

Numerical Study of Two-Dimensional Heaving Airfoils in Ground Effect

Theoretical Investigation on Two-Dimensional Wing-in-ground Effect in the Presence of a Free Surface

Nonlinear Lifting Theory for Unsteady WIG in Proximity to Incident Water Waves. Part 2: Three-dimension

Numerical study on the water entry of two-dimensional airfoils by BEM

Nonlinear Lifting Theory for Unsteady WIG in Proximity to Incident Water Waves. Part 1: Two-dimension

Nonlinear Analysis on a 2D WIG Operating NearWater Waves

Numerical Study of Two Dimensional Flow on an Oscillating Airfoil

Numerical study of a semi-passive oscillating hydrofoil on power-extraction with wing-in-ground effect

Numerical Analysis of the Unsteady Aerodynamics of an Airfoil Flying at Subsonic Flow over a Wavy Surface

Numerical Simulation of the Vortex Shedding and Lock-In Phenomenon of an Active Vibration Hydrofoil

Numerical Investigation on the Effect of Asymmetry of Flow Velocity on the Wake Vortex of Hydrofoils

Numerical Study of Aerodynamics of A Wing-In-Ground-Effect Craft

Numerical Investigation of an Oscillating Airfoil Using Immersed Boundary Method

Numerical Investigation of Unsteady Cavitation Dynamics over a NACA66 Hydrofoil Near a Free Surface

Study of the influence of water wave on the unstable cavitating flow of a hydrofoil

Numerical Simulation on Aerodynamic of the Wing in Ground Effect

Numerical simulation of wake vortex for the flight near the ground with different boundary conditions

A three-dimensional wake impingement model and applications on tandem oscillating foils

Numerical Investigation on the Dynamic Behavior of Sheet/cloud Cavitation Regimes Around Hydrofoil

Two-dimensional Hydrofoil Hydrodynamic Performance and Waveform Evolution Studies in Density Stratification and Homogeneous Fluid

Numerical Investigation of the Effects of Wind Tunnel Model Vibrations on the Measured Aerodynamic Properties of Airfoils and Wings