Abstract:A flexible wing with a large aspect ratio emerges in many modern engineering applications (e.g. solar planes and super large wind turbine blades) and its interaction with incident flow differs markedly from conventional fluid-structure interactions (FSI), exhibiting frequently a large three-dimensional (3D) deformation. Yet, there is little information on how such deformation may change wing aerodynamics. This work investigates the aerodynamic performance of deformed and cantilever- supported NACA0012 rigid wings with an aspect ratio of 9, using ANSYS Fluent with the SST-kappa-w turbulence model at a chord-length-based Reynolds number Recof c of 1.5 x 105. 5 . Numerical simulation is validated experimentally. The wing tip bending displacement is up to 4.14c, and the maximum twisted angle is up to 7 degrees. degrees . The angle alpha of attack varies from 0 degrees degrees to 20 degrees degrees at mid span of the wing. It has been found that the torsional deformation can significantly advance the local flow separation, reattachment, bubble length, and transition from laminar to turbulence, resulting in a drop in the critical angle alpha cr of attack, at which the separation bubble size reaches the maximum. Accordingly, the lift and drag coefficients increase, as well as the bending and pitching-up moments, though the stall is advanced due to a change in local alpha. The tip vortex is also enhanced, inducing strong downwash postponing the separation bubble on the wing and resulting in redistributed force near the wing tip that increases markedly the local bending moment but decrease the local pitching-up moment. On the other hand, the bending deformation tends to produce an effect opposite to the torsion on the flow structure and causing little change in the lift coefficient, though reducing the induced drag and moments appreciably. With both deformations in place, the torsion overwhelms the bending in general in terms of its impact upon aerodynamics and flow structures, the latter acting to cancel at least partially the effect of the former.

Force production and asymmetric deformation of a flexible flapping wing in forward flight

Effect of the Wing Morphology and Structural Form on the Flexible Hovering Flapping Wing

Analysis of nonlinear aerodynamic performance and passive deformation of a flexible flapping wing in hover flight

Effect of Wing Flexibility on the Lift Force Generated by a 2D Model Insect Wing Flapping in Hover Mode

Aerodynamic performance of flexible flapping wings deformed by slack angle

An analytical model and scaling of chordwise flexible flapping wings in forward flight

Investigation of chordwise functionally graded flexural rigidity in flapping wings using a two-dimensional pitch-plunge model

Dynamic pitching of an elastic rectangular wing in hovering motion

The spatial-temporal effects of wing flexibility on aerodynamic performance of the flapping wing

Aerodynamic performance of a hovering hawkmoth with flexible wings: a computational approach

Fluid-structure coupling research for micro flapping-wing

Kinematic Optimization of a Flexible Wing Undergoing Flapping and Pitching

Fluid-structure interaction in compliant insect wings

Experimental Study on Flexible Deformation of a Flapping Wing with a Rectangular Planform

Kinematics, Deformation, and Aerodynamics of a Flexible Flapping Rotary Wing in Hovering Flight

Experimental characterization of a flexible membrane flapping-wing in forward flight

Aerodynamic Performance of Micro Flexible Flapping Wing by Numerical Simulation

Experimental and computational studies of the aerodynamic performance of a flapping and passively rotating insect wing

Effects of spanwise flexibility on the performance of flapping flyers in forward flight

Effect of flexibility on flapping wing characteristics under forward flight

Aerodynamics of a Three-Dimensionally Deformed Rigid Wing