Abstract:The dynamic response experiment has been a difficult point of the metal/polymer interfacial bonding performance testing, in which the metal surface state and the loading condition are key independent variables that should be comprehensively investigated. This work investigates the effect of loading velocity and Al surface porosity on Al/PMMA interfacial dynamic shear bonding performance. Firstly, simulation is applied to predict dynamic response variation trends. Simulation results show that the maximum force (MF) has minor changes with initial bullet velocity (IBV), while the de-bonding displacement (DD) and interface failure work (IFW) decrease obviously with IBV. All three indicators increase smoothly with the area ratio of PMMA interlocks. In experiment, the result plots of the indicators are all discrete, but as a whole, the MF plots could not be distinguished by the variation of IBV, while the plots of DD and NW decrease with IBV, which are consistent with simulation. The dynamic response indicators obtained by simulation and experiment show similar variation trends with their respective independent variables at certain ranges (surface porosity: − 15–20%/dm 2 , area ratio: 0–0.33) and could be contrasted to evaluate the indicator value differences at full range. By further analysis within MF and DD indicators, the stability of the dynamic interfacial stiffness is discovered at their respective loading velocities, which is similar static loading in past work. The strengthening and weakening mechanisms of Al/PMMA interface are also inferred. This experiment–simulation combined work exhibits a systematic method to predict the dynamic response with the variation of the independent investigating variables at certain ranges, to evaluate the degree of deviation of the experimental plots from simulative ones and to help determine the porosity range where higher dynamic response would be obtained, which would be also applied to other metal/polymer layered system.

Dynamic Friction Coefficient of Two Plastics Against Aluminum under Impact Loading

A Technique for Measuring Dynamic Friction Coefficient under Impact Loading

A Friction Evaluation Method Based on Barrel Compression Test

Impact Friction Test For Friction Materials

Direct Measurement of Plowing Friction and Wear of a Polymer Thin Film Using the Atomic Force Microscope

A theoretical analysis about the influence of interfacial friction in SHPB tests

Dynamic Behavior of Aluminum Alloy Aw 5005 Undergoing Interfacial Friction and Specimen Configuration in Split Hopkinson Pressure Bar System at High Strain Rates and Temperatures

Friction characteristics of polymers applicable to small-scale devices

Anomalous Lubrication Behavior of Metal-Polymer Tribo-Pairs

Numerical and Theoretical Analysis of the Inertia Effects and Interfacial Friction in SHPB Test Systems

Friction Coefficient of Single-Crystal Aluminum Oxide under Low Sliding Velocity Conditions with Metal and Polymer Materials

Static friction of normal and reversed metal–polymer sliding pairs

Experimental investigation on dry frictional behavior of the two self-lubricating composites under heavy loading conditions

Numerical Investigation on Polyurea Coated Aluminum Plate Subjected to Low Velocity Impact

Assessment of Multilayered Plates with Hyperelastic Coatings Subjected to Dynamic Loadings by Impact at Low Velocities

Simulative and experimental study of metal/polymer interfacial dynamic shear response

An Experimental Method for Characterizing Friction Properties of Sheet Metal under High Contact Pressure

Differences in Tribological Behaviors upon Switching Fixed and Moving Materials of Tribo-pairs including Metal and Polymer

A novel friction model for steel‐polymer interfaces in sliding seismic isolation bearings

Experimental and modelling study of interaction between friction and galling under contact load change conditions

Experimental analysis on friction materials for supplemental damping devices