Abstract:We have attempted to apply the computer-based finite element analysis (FEA) method to accurately measure the mechanical properties (e.g., hardness and elasticity) of a soft material by an indentation test. First, an axisymmetric model has been developed using commercially available FEA code ANSYS. The FEA model consisted of a thin Al-film resting on Si-substrate. A spherical indenter has been used to indent the Al-film, which traveled a predefined depth during the loading and unloading cycles. First, numerical simulations were conducted to get the force vs. displacement plot, which was later used to determine the modulus of elasticity and hardness of Al-film. The effects of substrate modulus and indentation depth were thoroughly investigated to determine the modulus and hardness of Al-film. The effect of friction, considered at the interface of indenter and Al-film, was found to offer minimum impact for relatively small indentation depth. The induced force on the Al-film by the indenter has been found to be higher with increasing indentation depth when friction was considered. However the contact stiffness, represented by the slope of the unloading curve, has been found almost the same with and without considering friction. The variation of substrate modulus has been found to be ineffective to capture the Al-film modulus for relatively small indentation depth. However for higher indentation depth, the substrate modulus has been found to offer profound effect to capture the film modulus. The hardness of the Al-film has also been found to be relatively unaffected with variation of substrate modulus. However, the hardness of the Al-film has been found to be higher with friction for relatively high indentation depth. Results obtained from this preliminary research are important to continue further investigation and to characterize the mechanical properties of other soft-materials, e.g., biofilms to minimize its detrimental effects and utilize its favorable aspects in industrial and biomedical applications.

Nano/micro mechanics study of nanoindentation on thin Al/Pd films

Analysis of deformation behaviour of Al–Ni–Co thin film coated aluminium during nano-indentation: a molecular dynamics study

STUDY ON THE NANOINDENTATION VIA ATOMIC FORCE MICROSCOPE AND MOLECULAR DYNAMICS SIMULATION

Molecular Dynamic Simulations of Nanoindentation in Aluminum Thin Film on Silicon Substrate

Investigation on Dynamic Hardness and High Strain Rate Indentation Size Effects in Aluminium (110) Using Nano-Impact

Instrumented Microindentation of Nanoporous Alumina Films

In Situ Nanoindentation Mechanical Property of Films by Atomic Force Microscope

Nanoindentation Experimental Approach and Numerical Simulation of Al/Cr Bilayer Films

Multiscale Simulation of Surface Defects Influence Nanoindentation by a Quasi-Continuum Method

Nanoindentation in alumina coated Al: Molecular dynamics simulations and experiments

Investigation of the mechanical properties of thin films by nanoindentation, considering the effects of thickness and different coating–substrate combinations

Size Dependent Nanoindentation of a Soft Film on a Hard Substrate

Nano-Indentation for Characterizing Mechanical Properties of Soft Materials

Al-Pd interatomic potential and its application to nanoscale multilayer thin films

Atomistic Simulation of the Nanoindentation Behavior of Graphene/al Multilayered Nanocomposites

Numerical study on the measurement of thin film mechanical properties by means of nanoindentation

Indentation stress–strain analysis and finite element simulation to determine elastoplastic properties of thin films decreasing the substrate contribution

Molecular dynamics simulation and experimental study on nanoindentation response of polycrystalline γ-TiAl alloy

Mechanical and tribological properties of Ni/Al multilayers—A molecular dynamics study

Molecular Dynamics Simulation of Nanoindentation on Cu/Ni Nanotwinned Multilayer Films Using a Spherical Indenter.

Study of nanoindentation behavior of NiCrCoAl medium entropy alloys under indentation process using molecular dynamics