10 Gb/S 16-Quadrature Amplitude Modulation Signal Delivery over A Wireless Fiber System by Using A Directly Modulated Laser for Electrical/Optical Conversion

Lun Zhao,Jianguo Yu
DOI: https://doi.org/10.3788/col201513.060601
IF: 2.56
2015-01-01
Chinese Optics Letters
Abstract:We propose and experimentally demonstrate a novel scheme to realize electrical/optical(E/O) conversion on the receiver side of a wireless fiber integration system at the W band. At the receiver, a directly modulated laser(DML) is used to realize E/O conversion. The received 85 GHz wireless millimeter-wave(mm-wave) signal is first down-converted into a 10 GHz electrical intermediate-frequency(IF) signal to overcome the insufficient bandwidth of the subsequent DML. Then, two cascaded electrical amplifiers(EAs) are employed to boost the electrical IF signal before it is used to drive a DML. By using this scheme, we transmit a 10 Gb/s 16 quadrature amplitude modulation(16QAM) signal over a 10 m wireless link, and then deliver it over a 2 km single-mode fiber-28(SMF-28) wire link with a bit error ratio(BER) that is less than the hard-decision forward error correction threshold of 3.8 × 10-3. Our experimental results show that the DML is good device to be used for the E/O conversion of a 16 QAM signal.
What problem does this paper attempt to address?