Abstract:Excitation-emission matrix spectroscopy (EEMs) was widely used in food science, analytical chemistry, biochemistry and environmental science because of its wealth of information and high sensitivity. However, the Rayleigh and Raman scatterings bring difficulties to display data and quantitative analysis of EEMs. Therefore, in the early stage of data processing, eliminating the scatterings' interference is significant for the popularization and application of EEMs. In previous studies, few researchers aimed to deal with the low-concentration solution and the scattering peaks overlap with the material fluorescence signals. In order to solve this problem, the paper proposed a self-adapting method to remove the scatterings of EEMs. First, the method corrects the Raman scatterings and background interference by subtracting the spectral baseline of the solvent obtained in each experiment. Then, according to the intensity and overlap degree of fluorescence signals and scattering peaks. EEMs are divided into five categories corresponding to three overlap levels: no overlap, weak overlap and serious overlap. The Rayleigh scatterings are corrected by setting to zero, piecewise cubic Hermite interpolation polynomial algorithm and Gaussian-piecewise cubic Hermite interpolation polynomial coupling algorithm, respectively. The method is based on one-dimensional interpolation, and only emission spectrums are studied, reducing the algorithm's complexity and computation time. The method's effectiveness was demonstrated by the experiments on four typical organic compounds: Tyrosine, Fulvic acid, Naphthalene acetic acid and Rhodamine B. Moreover, compared with the Delaunay interpolation method, which is most used in current research. The concentration regressions are performed with the EEMs after the scatterings' correction; the average of -R-squared obtained by the method is 0.9962, which is 5.04% higher than the Delaunay interpolation method. At the same time, by comparing the EEMs of Fulvic acid corrected by the method and Delaunay interpolation method, it is proved that this method can better maintain the structural characteristics of the fluorescence spectral regions and effectively avoid the occurrence of overfitting. Finally, this method is used to monitor the simulated sudden pollution water samples, which verifies that the method has good universality and practical application value. It provides a novel idea for removing scatterings' interference of EEMs.

A novel alternating least-squares method based on fixed region scanning evolving factor analysis (FRSEFA) and its application in process monitoring

A Selective Moving Window Partial Least Squares Method and Its Application in Process Modeling

RE SEARCH ON EN ERGY SPEC TRUM ANOM ALY DE TEC TION METHOD FOR STATE CON TROL RA DI A TION EN VI RON MEN TAL MON I TOR ING BASED ON LOF AL GO RITHM

An Automated Diagnostic Framework for Multiple Oscillations with Median Complementary EEMD

Investigation of an On-Line Detection Method Combining Near Infrared Spectroscopy with Local Partial Least Squares Regression for the Elution Process of Sodium Aescinate

The application of frequency and amplitude response spectroscopy analyzing

Phase-Based Joint Modeling and Spectroscopy Analysis for Batch Processes Monitoring

Recursive Mixture Factor Analyzer for Monitoring Multimode Time-Variant Industrial Processes

A Self-Adapting Method for Removing Scatterings in the Excitation-Emission Matrix Spectroscopy

Adaptive handling of Rayleigh and Raman scatter of fluorescence data based on evaluation of the degree of spectral overlap

Error Analysis And New Dual-Cosine Window For Estimating The Sensor Frequency Response Function From The Step Response Data

Exponential Stationary Subspace Analysis for Stationary Feature Analytics and Adaptive Nonstationary Process Monitoring

An Applied Frequency Scaling Algorithm Based on Local Stretch Factor for Near-Field Miniature Millimeter-Wave Radar Imaging

Monitoring method and application of transition process with nonstationary conditions based on stability factor partitioning and RSFA

Spectra Data Analysis and Calibration Modeling Method Using Spectra Subspace Separation and Multiblock Independent Component Regression Strategy

Estimation of feeding composition content based on novel variable sliding window method and layered data reconciliation with multiple modes

Spectral envelope-based adaptive empirical Fourier decomposition method and its application to rolling bearing fault diagnosis

An Improved Statistical Modeling Strategy by Spectroscopy for Online Monitoring and Diagnosis of Batch Processes

Single sample electromagnetic spectrum recognition utilizing fractional Fourier transform

A novel time–frequency–space method with parallel factor theory for big data analysis in condition monitoring of complex system

Separation of Temperature-Induced Response for Bridge Long-Term Monitoring Data Using Local Outlier Correction and Savitzky-Golay Convolution Smoothing