Abstract:Speed – density relationship, which is usually referred to as the traffic flow fundamental diagram, has been considered as the foundation of the traffic flow theory and transportation engineering. Speed - density relationship is the foundation of the traffic flow theory and transportation engineering, as it represents the mathematical relationship among the three fundamental parameters of traffic flow. It was long believed that single regime models could not well represent all traffic states ranging from free flow conditions to jam conditions until Qu et al. (2015) pointed out that the inaccuracy was not caused solely by their functional forms, but also by sample selection bias. They then applied a new calibration method (named as Qu-Wang-Zhang model hereafter) to address the sample selection bias. With this Qu-Wang-Zhang model, the result calibrated from observational data sample can consistently well represent all traffic states ranging from free flow conditions to traffic jam conditions. In the current paper, we use a fundamentally different approach that is able to yield very similar and consistent results with the Qu-Wang-Zhang model. The proposed approach firstly applies reproducible sample generation to convert the observational data to experimental data. The traditional least square method (LSM) can subsequently be applied to calibrate accurate traffic flow fundamental diagrams. Two reproducible sample generation approaches are proposed in this research. Based on our analyses, the first approach is somewhat affected by outliers and the second approach is more robust in dealing with potential outliers.

On the fundamental diagram for freeway traffic: A novel calibration approach for single-regime models

On the Fundamental Diagram for Freeway Traffic: Exploring the Lower Bound of the Fitting Error and Correcting the Generalized Linear Regression Models

Spatio-Temporal Evolution of Traffic Congestions on Urban Freeways

Model on Empirically Calibrating Stochastic Traffic Flow Fundamental Diagram

On the Stochastic Fundamental Diagram for Freeway Traffic: Model Development, Analytical Properties, Validation, and Extensive Applications

Integrated Control of Internal Boundary and Ramp Inflows for Lane-free Traffic of Automated Vehicles on Freeways.

Phase Diagram Analysis Based on a Temporal-Spatial Queueing Model.

A Two-Dimensional CA Traffic Model with Dynamic Route Choices Between Residence and Workplace

Freeway Network Simulation and Dynamic Traffic Assignment with Metanet Tools

Multimodel Ensemble for Freeway Traffic State Estimations

A Novel Approach to Estimating Missing Pairs of On/Off Ramp Flows

A Identification Algorithm of Freeway Steady-State Speed-Density Balance Relational Expression Based on the Power Series Expansion and the Least Squares Method

A Structural Raffic Flow Model for Urban Arterial Roads

Survey on urban freeway traffic control

Equivalent Queue Length Change Rate Models for Congested Traffic Flow

Reproducible generation of experimental data sample for calibrating traffic flow fundamental diagram

Equivalent queue length model for congested traffic stream based on two-fluid theory

Freeway Traffic Stream Modeling Based on Principal Curves and Its Analysis

A COMPARATIVE STUDY ON TRAFFIC FLOW MODELS BASED ON MEASURED DATA

A Novel Approach to Estimate Freeway Traffic State: Parallel Computing and Improved Kalman Filter.

Fundamental Diagrams of 1D-Traffic Flow by Optimal Control Models