Abstract:The goal of this paper is to describe an active decentralized fault-tolerant control (ADFTC) strategy based on dynamic output feedback for reconfigurable manipulators with concurrent actuator and sensor failures. Consider each joint module of the reconfigurable manipulator as a subsystem, and treat the fault as the unknown input of the subsystem. Firstly, by virtue of linear matrix inequality (LMI) technique, the decentralized proportional-integral observer (DPIO) is designed to estimate and compensate the sensor fault online; hereafter, the compensated system model could be derived. Then, the actuator fault is estimated similarly by another DPIO using LMI as well, and the sufficient condition of the existence of H∞ fault-tolerant controller in the dynamic output feedback is presented for the compensated system model. Furthermore, the dynamic output feedback controller is presented based on the estimation of actuator fault to realize active fault-tolerant control. Finally, two 3-DOF reconfigurable manipulators with different configurations are employed to verify the effectiveness of the proposed scheme in simulation. The main advantages of the proposed scheme lie in that it can handle the concurrent faults act on the actuator and sensor on the same joint module, as well as there is no requirement of fault detection and isolation process; moreover, it is more feasible to the modularity of the reconfigurable manipulator.

Dynamic Output Feedback Based Active Decentralized Fault-Tolerant Control for Reconfigurable Manipulator with Concurrent Failures

Decentralized Sliding Mode Observer Based Dual Closed-Loop Fault Tolerant Control for Reconfigurable Manipulator against Actuator Failure

Active substituting decentralized fault-tolerant control for reconfigurable manipulators with multi-sensor failures

Decentralized Force/Position Fault-Tolerant Control For Constrained Reconfigurable Manipulators With Actuator Faults

Fault Tolerant Control For Reconfigurable Manipulators Based On Adaptive Dynamic Programming With An Improved Performance Index Function

Local Joint Information Based Active Fault Tolerant Control for Reconfigurable Manipulator

Self-Tuned Local Feedback Gain Based Decentralized Fault Tolerant Control of Reconfigurable Manipulators

Signal Reconstruction Based Active Decentralized Fault Tolerant Control for Reconfigurable Manipulators

Robust Decentralized Force/Position Fault-Tolerant Control for Constrained Reconfigurable Manipulators Without Torque Sensing

Decentralized Fault Tolerant Control of Modular Manipulators System Based on Adaptive Dynamic Programming

Multiple Faults Detection and Isolation Via Decentralized Sliding Mode Observer for Reconfigurable Manipulator

Active Optimal Fault-Tolerant Control Method For Multi-Fault Concurrent Modular Manipulator Based On Adaptive Dynamic Programming

ADP-based active optimal fault-tolerant control for modular manipulator with multiple sensor failure

Active Fault-Tolerant Control Integrated with Reinforcement Learning Application to Robotic Manipulator

Decentralized fault tolerant control for reconfigurable modular robots

Adaptive Fault-Tolerant Control for a Joint Flexible Manipulator Based on Dynamic Surface

Torque Sensorless Decentralized Position/Force Control for Constrained Reconfigurable Manipulator via Non-fragile H-infinity Dynamic Output

Sensor Fault Identification and Decentralized Fault-Tolerant Control of Reconfigurable Manipulator Based on Sliding Mode Observer

Fault- Tolerant Control For Robotic Manipulator With Uncertain Dynamics And Disturbance

Adaptive Fault-tolerant Control of Robotic Manipulators with Given Transient and Steady-state Performance and Dynamic Uncertainties

Optimal Fault Tolerant Control of Reconfigurable Manipulator with Actuator Saturation