Abstract:Data assimilation technique (adjoint method) is applied to study the similarities and the differences between the Ekman (linear) and the Quadratic (nonlinear) bottom friction parameterizations for a two-dimensional tidal model. Two methods are used to treat the bottom friction coefficient (BFC). The first method assumes that the BFC is a constant in the entire computation domain, while the second applies the spatially varying BFCs. The adjoint expressions for the linear and the nonlinear parameterizations and the optimization formulae for the two BFC methods are derived based on the typical Largrangian multiplier method. By assimilating the model-generated ‘observations’, identical twin experiments are performed to test and validate the inversion ability of the presented methodology. Four experiments, which employ the linear parameterization, the nonlinear parameterizations, the constant BFC and the spatially varying BFC, are carried out to simulate the M2 tide in the Bohai Sea and the Yellow Sea by assimilating the TOPEX/Poseidon altimetry and tidal gauge data. After the assimilation, the misfit between model-produced and observed data is significantly decreased in the four experiments. The simulation results indicate that the nonlinear Quadratic parameterization is more accurate than the linear Ekman parameterization if the traditional constant BFC is used. However, when the spatially varying BFCs are used, the differences between the Ekman and the Quadratic approaches diminished, the reason of which is analyzed from the viewpoint of dissipation rate caused by bottom friction. Generally speaking, linear bottom friction parameterizations are often used in global tidal models. This study indicates that they are also applicable in regional ocean tidal models with the combination of spatially varying parameters and the adjoint method.

Estimation of Bottom Friction Coefficients Based on an Isopycnic-Coordinate Internal Tidal Model with Adjoint Method

Application of Surface Spline Interpolation in Inversion of Bottom Friction Coefficients

Estimation of Bottom Friction Coefficient in Multi‐Constituent Tidal Models Using the Adjoint Method: Temporal Variations and Spatial Distributions

Adjoint estimation and interpretation of spatially varying bottom friction coefficients of the M 2 tide for a tidal model in the Bohai, Yellow and East China Seas with multi-mission satellite observations

Study on Linear and Nonlinear Bottom Friction Parameterizations for Regional Tidal Models Using Data Assimilation

Estimation of Spatially Varying Open Boundary Conditions for a Numerical Internal Tidal Model with Adjoint Method

Numerical Simulation of Water Entry of Two-Dimensional Structures with Complex Geometry Using a CIP-based Model

Estimation of Eddy Viscosity Profile in the Bottom Ekman Boundary Layer

A Cip-Based Numerical Simulation Of Green Water On A 2-D Floating Body

Numerical and Experimental Study on A 2-D Floating Body under Extreme Wave Conditions

Effects of spatial bottom friction parameterization scheme on the tidal dynamics in the macrotidal East China Seas

Optimization of Open Boundary Conditions in a 3D Internal Tidal Model with the Adjoint Method Around Hawaii

A method for inversion of periodic open boundary conditions in two-dimensional tidal models

Inversion of Two-Dimensional Tidal Open Boundary Conditions of M 2 Constituent in the Bohai and Yellow Seas

An Improved CIP-based Numerical Model for Simulating Free-Surface Flow with Adaptive Mesh

Inverse Estimation of Open Boundary Conditions in the Bohai Sea

A Methodology for Estimating the Parameters in Three-Dimensional Cohesive Sediment Transport Models by Assimilating in Situ Observations with the Adjoint Method

Estimation of the Reflection of Internal Tides on a Slope

A Numerical Study of Water Entry of Asymmetric Wedges Using a CIP-based Model

Numerical Evaluation of Internal Tide Characteristics Extracted from Mobile Float Observations: A Case Study Near the Luzon Strait

Sensitivities of Bottom Stress Estimation to Sediment Stratification in a Tidal Coastal Bottom Boundary Layer