Abstract:Flexoelectric material under certain inhomogeneous electric field can be utilized to control the vibration of flexible structure based on the converse flexoelectric effect. The atomic force microscope (AFM) probe placed on the top of flexoelectric patch and the electrode under it with certain voltage applied between them are used to generate the inhomogeneous electric field. The actuation membrane force and bending moment induced by flexoelectric patch in turn influence the vibration of shells. In this study, an elastic cantilever beam excited by an initial static mechanical force locating at the tip end is considered. As the mechanical force withdraws the snapback response appears where the cantilever beam vibrates with all mode participating and their amplitudes decaying exponentially. Multiple actuators, consist of AFM probes and flexoelectric patches, are used here to accelerate the decrease of snapback response. On each probe voltages of multiple frequencies are applied to obtain the control effects on multiple modes. The actuator’s positions minimizing the tip displacement of the beam is selected as the optimal ones. Two way of determining the control voltage, i.e., open loop and close loop, is introduced and the information of positions of the actuators are emphasized in both methods. In case studies, the free damping vibration of the beam without control is evaluated and the first mode dominates the vibration. The open loop method, with constant amplitude of control voltage, doesn’t work well in a relatively long time scale. While the close loop method, with its control voltage related to the tip displacement detected by a sensor, turns out to be more stable and effective. The optimal positions for the actuations of both methods are clustered near the fixed end, where the actuation factor reaches its maximal value. At last, limitation on voltage amplitude is implemented to avoid the stress concentration, under which the control effect does not weaken much. This study serves as an introduction to flexoelectric material & multiple AFM probe based vibration control and a theoretical foundation for further researches.

Electrostatic cantilever resonators under a double-sided pull–pull drive scheme

Pull-In Dynamics of Two MEMS Parallel-Plate Structures for Acceleration Measurement

Electrostatic resonator with second superharmonic resonance

Pull-In Effect of Suspended Microchannel Resonator Sensor Subjected to Electrostatic Actuation

Electrostatic Comb-Drive Actuator for Mems Relays/Switches with Double-Tilt Comb Fingers and Tilted Parallelogram Beams

Mechanical Behaviors Research and the Structural Design of a Bipolar Electrostatic Actuation Microbeam Resonator

Static Nano-Control Of Cantilever Beams Using The Inverse Flexoelectric Effect

Flexoelectric Control of Beams with Atomic Force Microscope Probe Excitation

Parametric Analysis of Electrostatic Comb Drive for Resonant Sensors Operating under Atmospheric Pressure

Design and experiment of push-pull MEMS Resonant Accelerometers

Rigid Electrodes Enhance the Strain and Force Output of Peano-HASEL Actuators

Single-Electrode Electrostatic Repulsion Phenomenon for Remote Actuation and Manipulation

Control of Beam’s Snapback Responses Using Multiple Flexoelectric Actuators

Electrostatic pull-in instability in MEMS/NEMS: A review

A Hybrid Photovoltaic/flexoelectric Actuation Mechanism Applied to Precision Actuation and Vibration Control of Beams

Electrostatic Charge Sensor Based on Micro Resonator with Sensing Scheme of Effective Stiffness Perturbation

The levitation and driving performance of a contact-free manipulation device actuated by ultrasonic energy

Analysis of Parametric and Subharmonic Excitation in Push-Pull Driven Disk Resonator Gyroscopes

On the Driving Mechanism Design for Large Amplitude Electrostatic Actuation

Micromechanical resonant electrostatic charge sensor with micro-leverage mechanisms

Analysis of Impact of Bottom Electrode Position on Dynamic Pull-In Parameters of Microcantilevers