Abstract:Dielectric elastomer(DE) is a kind of promising material bearing excellent activate properties including large deformations (up to 380%), high energy densities (up to 3.4 J/g), high efficiency, high responsive speed, good reliability and durability. Thus the DE actuator, sensors and energy harvester is widely used in the field of aeronautics and smart bionics. When an electric field is applied on the compliant electrodes of the dielectric elastomers, the polymer shrinks along the electric field and expands in the transverse plane. In consequence, the electric field becomes higher. This kind of positive feedback may cause the elastomer to thin down, resulting in an electromechanical stability. An analysis on the electromechanical stability of dielectric elastomer using arbitrary free-energy function with constant dielectric constant has been presented in Suo’s papers. In many research on the electromechanical stability analysis of DE actuator, DE’s dielectric constant is assumed to be a constant. This is only the truth if the dielectric elastomer undergoing limited deformation. Actually, a typical dielectric elastomer is a kind of crosslinked polymer. The structural symmetry of the macromolecular, the crosslinking degree, along with the tensile deformation can affect the dielectric permittivity enormously. For dielectric elastomers with higher crosslinking degree, or higher degree of molecular structural symmetry, its permittivity is relatively low. In addition, stretching can guide the macromolecule to be arranged in order, this can increase the intermolecular forces and reduce the activities of polar group, as a results, the dielectric constant will decrease. However, if the crosslinking degree is low and the deformation is well below the extension limit, the molecular units in the polymers can be polarized as freely as in a polymeric liquid. In this case the corresponding permittivity is unaffected by the deformation. Recent experimental research results also proved that the dielectric permittivity of dielectric elastomer changed while undergoing large deformation. According to Pelrine, the dielectric constant of the DE film is variable and it is a function of the area increase ratio which depends on stretch ratio. In this paper, approach for the electromechanical stability of a dielectric elastomer having variable dielectric constant is developed. The critical breakdown electric field is obtained. Simulation results proved that the prestretching process can enhance remarkably the electromechanical stability of dielectric elastomer. These results agree well with the experimental data and can be used as guidances in the design and fabrication of dielectric elastomer actuators.

Effects Of Stretching Rate And Size On The Rupture Of Acrylic Dielectric Elastomer

Mechanisms of large actuation strain in dielectric elastomers

Electromechanical Behavior Of Fiber-Reinforced Dielectric Elastomer Membrane

The Temperature-Dependent Viscoelastic Behavior of Dielectric Elastomers

Giant voltage-induced deformation in dielectric elastomers near the verge of snap-through instability

Electromechanical Stability Of Dielectric Elastomer Using Electric Energy Density Function With Variable Dielectric Constant

Giant, Voltage-Actuated Deformation of a Dielectric Elastomer under Dead Load

Experimental Study on Pure-Shear-like Cyclic Deformation of VHB 4910 Dielectric Elastomer

Experimental Characterization and Finite Element Modeling the Deformation Behavior of Rubbers with Geometry Defects

Rate Dependent Stress-Stretch Relation of Dielectric Elastomers Subjected to Pure Shear Like Loading and Electric Field

Effects of stretching on crystalline phase structure and morphology of hard elastic PVDF fibers

Suppression of Electromechanical Instability in Fiber-Reinforced Dielectric Elastomers

Tunable Actuation of Dielectric Elastomer by Electromechanical Loading Rates

Experimental Investigation on Electro-Mechanically Coupled Cyclic Deformation of Laterally Constrained Dielectric Elastomer

Interfacial fatigue fracture of elastomer bilayers under cyclic large deformation

Mechanics of Dielectric Elastomers: Materials, Structures, and Devices

Fabrication and actuation characterisation of a new UV curing acrylic dielectric elastomer

Optimizing parameters to achieve giant deformation of an incompressible dielectric elastomeric plate

The rate dependence of the dielectric strength of dielectric elastomers

Mechanics of dielectric elastomer structures: A review

Humidity effect on electromechanical breakdown of dielectric elastomers subject to a ramp voltage