Abstract:The injection molding process is a typical multi-phase batch process. As the filling and packing-holding phases share the same actuator, faults occurring in the actuators may cause serious impact on the performance and running time. Because these two phases are of crucial importance in relation to the final quality of the product, to solve this problem is essentially meaningful. This paper proposes iterative learning fault-tolerant control (ILTFC) in terms of common multi-phase batch processes and then applies it to the injection molding processes. To develop the ILFTC design, the multi-phase batch process is treated as a switched system composed of different dimensional subsystems and then converted to an equivalent two-dimensional (2D) switched fault-tolerant Rosser model. A hybrid fault-tolerant law is then designed based op an average dwell time method. Sufficient conditions and minimum running time guaranteeing the exponential stability under both normal and fault conditions are obtained. Under the proposed control law, the control performance and running time will restore to the previous level before actuator faults occur. The efficiency and merits of the proposed scheme is illustrated by an injection molding process, and results show that it can guarantee the stability and minimum running time whether the process is in normal operation or in case of actuator faults. (C) 2017 Elsevier Ltd. All rights reserved.

Step Response Identification under Inherent-Type Load Disturbance with Application to Injection Molding

Closed-loop Step Identification of Low-Order Continuous-Time Process Model with Time Delay for Enhanced Controller Autotuning

Closed-loop Step Response Identification of Integrating and Unstable Processes

A New Fuzzy Self-Tuning Method for Controlling Packing Pressure of a High-Accuracy Injection Molding Machine

Identification and Autotuning of Temperature-Control System With Application to Injection Molding

Disturbance Observer Based Speed Control of a Variable Displacement Pump-Driven-Motor System with Impedance Torque Regulation.

Enhanced Imc Design of Load Disturbance Rejection for Integrating and Unstable Processes with Slow Dynamics

Robust Step-Like Identification of Low-Order Process Model under Nonzero Initial Conditions and Disturbance

Integrated Direct/Indirect Adaptive Robust Control for Electrical Driven Injection Machine Mold Closing with Accurate Parameter Estimations.

Identification of low-order unstable process model from closed-loop step test

Identification of Low-Order Process Model with Time Delay from Closed-Loop Step Test.

Subspace Model Identification under Load Disturbance with Unknown Transient and Periodic Dynamics

A Learning-Based Model Predictive Control Scheme for Injection Speed Tracking in Injection Molding Process

Identification of time delay model for integrating processes from closed-loop step test

Improved Infinite Horizon LQ Tracking Control for Injection Molding Process Against Partial Actuator Failures

A Frequency Domain Step Response Identification Method for Continuous-Time Processes with Time Delay

Injection Velocity Control of Thermoplastic Injection Molding Via A Double Controller Scheme

Iterative Learning Fault-Tolerant Control for Injection Molding Processes Against Actuator Faults

Optimal Tracking Control of Injection Speed in Injection Molding Machine with Gaussian Process Learning and Model Predictive Control

A Systematic Approach for On-Line Identification of Second-Order Process Model from Relay Feedback Test

Modeling and Control of an Electro-hydraulic Injection Molding Machine With Smoothed Fill-to-Pack Transition