Abstract:Refrigeration systems based on electrocaloric materials are considered as potential alternatives for the current vapor compression–based devices. These systems offer efficiencies closer to the Carnot limits, while also being compatible with miniaturization, compactness, and integration into electronics and wearables. Several prototypes have been proposed that mostly rely on mechanical and fluid motion for heat transfer, which prevent these systems from reaching higher operation frequency, good thermal contact, and low loss. Motionless electrocaloric solid-state devices have so far been conceptualized, but their relative complexity has hampered prototyping. In this work, we study the performance of a solid-state electrocaloric cooler that relies on thermoelectric switches to control heat flow. Our device operation mode minimizes energy consumption by absorbing heat passively through the heat switches. The applied currents, absorbed heat, power consumption, and coefficient of performance are assessed for a wide set of parameters following a steady-state heat propagation model, covering operation temperature, material properties, geometric features, frequency of operation, and material polarization losses. We show that a coefficient of performance (COP) above 1 can be obtained for temperature spans up to 6 K (for different material properties, geometry factors, or electrocaloric loss) and adiabatic temperature changes around 1 K higher than the applied temperature span. Higher temperature spans between 6 to 10 K yield a COP of the order of 0.1, leading to a significant increase in power consumption. These results are intended to guide research into these solid-state devices, in terms of choice of materials, temperatures, and geometry. https://doi.org/10.1103/PhysRevApplied.21.054021 © 2024 American Physical Society

Study on High Efficient Heat Recovery Cycle for Solid-State Cooling

Modeling and Optimization of a Novel Heat Recovery Design for Thermoelastic Cooling Systems

Study on the Performance of a Novel Waste Heat Recovery System at Low Temperatures

Study of a Novel Hybrid Refrigeration System for Industrial Waste Heat Recovery

Utilization of Ultra-Low Temperature Heat by a Novel Cascade Refrigeration System with Environmentally-Friendly Refrigerants

Performance Analysis of a Novel Hybrid Vapor Injection Cycle with Subcooler and Flash Tank for Air-Source Heat Pumps

Experimental Study of a New Ejector-Absorption Refrigeration Cycle Driven by Multi-Heat Sources

A Heat Driven Elastocaloric Cooling System

A review of regenerative heat exchange methods for various cooling technologies

State-of-the-art and Prospects of Elastocaloric Cooling Technology

Thermodynamics Cycle Analysis and Numerical Modeling of Thermoelastic Cooling Systems

Thermodynamic Cycle Analysis of Heat Driven Elastocaloric Cooling System

Numerical Study of a Double-Effect Elastocaloric Cooling System Powered by Low-Grade Heat

Thermodynamics of Elastocasloric Cooling and Heat Pump Cycles

A High Performance Desiccant Dehumidification Unit Using Solid Desiccant Coated Heat Exchanger with Heat Recovery

High cooling performance in a double-loop electrocaloric heat pump

Thermodynamic Analysis and Comparison Study of Two Novel Combined Cooling and Power Systems with Separators Using CO2-based Mixture for Low Grade Heat Source Recovery

A Review of Elastocaloric Cooling: Materials, Cycles and System Integrations

A full solid-state conceptual magnetocaloric refrigerator based on hybrid regeneration

A Novel Heat Recovery VRF System: Principle and Cooling Performance Analysis

Solid-state electrocaloric cooler controlled by a thermal switch